U-Line H-7906 User manual

PAGE 1 OF 3 0319 IH-7906
πH-7906
3-STEP ALUMINUM
STEP STAND
1-800-295-5510
uline.com
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED
9/16" (14 mm) Wrench
WARNING! Please read and save these
instructions. Read carefully before attempting
to assemble, install, operate or maintain
the product described. Protect yourself and
others by observing all safety information.
Failure to comply with instructions could
result in personal injury and/or death. Retain
instructions for future reference. Assembly
and installation of the 3-Step Stand can be
inherently dangerous. Take all precautions
necessary during assembly and installation.
DANGER! Death or serious injury may occur if
improperly assembled or used.
• Assembly can be dangerous.
• Read all instructions thoroughly before
assembling and using.
• Take necessary precautions during the
assembly process.
• Do not fully tighten mounting bolts until
instructed to do so.
1. Remove the step stand from the packaging and
place on a level surface.
NOTE: If any parts appear damaged in any
way, STOP, do not proceed with assembly and
contact Uline.
2. Attach back panel to top of steps with 3/8-16 x 1/"
hex head cap screws and hex nuts. Do not fully
tighten. (See Figure 1)
Figure 1
PARTS
Safety Glasses
Steps x 1 3/8-16 x 1/" Hex Head Cap
Screw x 6 (Included)
3/8-16 Hex Nut x 6
(Included)
Back Panel x 1 Long Brace x 2
Short Brace x 2

PAGE 2 OF 3 0319 IH-7906
3. Connect the end of long brace to front leg using
3/8-16 x 1/" hex head cap screw and hex nut.
(See Figure 2)
4. Pivot the rear panel upward and pivot the long
bottom brace upward. Connect the other end of
long bottom brace to rear panel lug using the
3/8-16 x 1/" hex head cap screw. Do not attach
hex nut. (See Figure 3)
5. Connect the short brace to middle panel lug using
3/8-16 x 1/" hex head cap screw and hex nut.
(See Figure 4)
6. Pivot short brace up and connect to rear panel lug
over the long bottom brace, using the same hex
head cap screw. The short brace will be installed
over the long brace. Place hex nut onto hex head
cap screw where the braces connect to the rear
panel lug. Do not fully tighten. (See Figure 5)
7. Repeat steps three through eight for the remaining
long bottom and short middle braces on opposite
side. (See Figure 6)
DANGER! Do not use step stand unless all
components and the cap screws are in place
and nuts are securely tightened.
Figure 3
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 5
Figure 6
Figure 2
Figure 4

PAGE 3 OF 3 0319 IH-7906
8. Turn the step stand over onto a level surface.
(See Figure 7)
9. Tighten all of the hex nuts onto hex head cap screws.
All of the braces and connections should be tight
and not loose.
DANGER! Inspect the step stand for any
permanent deformation, corrosion, degradation
or any condition impairing protective capability.
If any of these conditions are suspected,
remove from service with warnings prohibiting
use prominently displayed on the step stand
until step stand can be replaced.
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
ASSEMBLY INSTRUCTIONS CONTINUED
Figure 7