ubabub Nifty Junior Bed User manual

FSupport plate assembly 10
GFinished assembly 11

12 x 60mm Screw 1 x Allen Key
10 x Locking Cam 20 x 25 Screw
10 x Connector Pin 4 x Support Plate
Note: Some hardware
retained from cot.
2 x Support Pin

Step 1 Select Side Rail, slide onto
Support Pin.
Step 2 Insert 3 x Screws into Lower
Rail, attach rail into Side Rail
(see Fig. 03) Turn screw clockwise
using Allen Key until tight.
Step 3 Repeat steps 1 & 2 with other
Side Rail.
Step 1 Lay Foot panel on the ground screw
holes facing up. Use screw driver to
insert 4 x Connecting Pins as per
diagram.
Step 2 Align Connecting Pins, slowly install
Foot Panel onto side rails checking
that all of the pins are connecting
properly.
Step 3 Insert Locking Cams with arrow
pointing towards the
Connecting Pins.
Step 4 Use Allen Key or Screwdriver to turn
Locking Cams clockwise, half a full
turn until tight (see Fig. 04 x 4).

x 4

Step 1 Select an L-shaped support plate and five screws.
Step 2 Install a support plate onto one the corners where the leg rails
meet the end panels as per diagram.
Step 3 Using a screwdriver install the five screws into the pre-drilled holes
securing the base plate to both the end panel and leg rails.
Step 4 Repeat steps 2 to 4 on each of the corners.
FSupport plate assembly
25mm
screws
Support
plate