Ubiquiti AF-5G-OMT-S45 User manual

5 GHz RocketDish™to airFiber®X
Antenna Conversion Kit
Model: AF-5G-OMT-S45

Introduction
Thank you for purchasing the Ubiquiti
Networks® 5 GHz RocketDish to
airFiberX Antenna Conversion Kit, model
AF‑5G‑OMT‑S45. The kit converts the
RocketDish RD‑5G30 or RD‑5G34 antenna
for use with an airFiber X radio. This Quick
Start Guide is designed to guide you
through the installation.
Package Contents
airFiber OMT Screws
(Qty, 5)
Seal Ring Phillips
Bit

Before You Begin
You'll need a driver for use with the
included Phillips Bit.
Note: The Phillips Bit has sharper
point detail to engage into the
painted screw recess. Japanese
Industrial Standard (JIS) type
screwdrivers with this profile are
available from online sources and
industrial suppliers.
Search for "JIS 1x75 screwdriver".
Select Tip No. 1.
Hardware Installation
To install the AF‑5G‑OMT‑S45, disassemble
the mounting hardware (refer to the
RocketDish Quick Start Guide if necessary)
to access the back of the antenna feed.
Once the back of the antenna feed is
accessible, perform the following steps:

1. Remove the ring, rubber gasket, and
washer around the SMA connector on
the rear right side of the RocketDish
antenna feed.

2. Use a driver with the included Phillips Bit
to remove the four screws holding the
SMA connector in place.

*640-00169-02*
640-00169-02
3. Remove the SMA connector.

4. Use a driver with the included Phillips Bit
to remove the screws securing the OMT
to the RocketDish.

5. Remove the OMT from the RocketDish.
Note: The Seal Ring Groove is
designed to hold the Seal Ring.
The existing Seal Ring may be
reused without removal. A new
Seal Ring is provided if needed.
Seal Ring Groove with Seal Ring

6. Align the airFiber OMT with the
connectors toward the radio mount and
the level horizontal.
Note: Only the five screws
included are used. Placement
depends upon the RocketDish.
Older RocketDish Models
The hole positions at one, three, five,
nine, and eleven o’clock are used.

Newer RocketDish Models
The hole positions at one, two‑thirty, five,
nine, and eleven o’clock are used.

7. Use a driver with the included Phillips
Bit to secure the airFiber OMT to the
antenna using the included five Screws.

www.ubnt.com
©2015 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti,
Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam
logo, airFiber, and RocketDish are trademarks or registered
trademarks of Ubiquiti Networks, Inc. in the United States
and in other countries. All other trademarks are the
property of their respective owners.
RR020415