Ubiquiti airMAX Omni AMO-5G10 User manual

Package content
installation requirements
Device installation
1.
13mm wrench
Rocket®M5 or RocketM5 GPS (sold separately)
Category 5 (or higher) shielded cabling must be used for all Ethernet connections
and must be connected to the AC ground of the PoE.
AMO-5G10 Quick Start Guide
We recommend that you protect your networks from harmful outdoor
environments and electrostatic discharge phenomena with Ubiquiti's
Industrial Grade Shielded Ethernet Cable. For more information, visit ui.com/
toughcable
Antenna
Serrated Flange Nuts (Qty:
4)
Foot Clamps (Qty: 2) Pan Head Screws (Qty: 4)
Cables RF (cant.: 2)

2.
AMO-5G10 Quick Start Guide

3.
AMO-5G10 Quick Start Guide

4.
AMO-5G10 Quick Start Guide

5.
AMO-5G10 Quick Start Guide

specs
0,68 kg (1,50 lb)
AMO-5G10
5,45 - 5,85 GHz
Dimensions
Weight with mounting
582 x 90 x 65 mm
(22,91 x 3,54 x 2,56")
Frequency
AMO-5G10 Quick Start Guide

AMO-5G10 Quick Start Guide
safety instructions
limited warranty
electrical safety information
ui.com/support/warranty
AMO-5G10
3. Only use the devices or accessories indicated by the manufacturer.
12°
Lineal doble
1,6:1
Gain
Connectors 2 RP-SMA (waterproof)
WARNING: Avoid using this product during a lightning storm. There is a remote possibility
of an electrical discharge caused by lightning.
1. It is mandatory to comply with the current, frequency and voltage requirements indicated on the
manufacturer's label. Connection to a power source other than those specified may result in
malfunction, equipment damage, or fire hazard if limitations are not followed.
71,17 N a 200 km/h
(16 lbf a 125 mph)
electric tilt down
ETSI specification
Wind resistance
Cross Polarity Isolation
2. Pay attention to all warnings.
10 dBi
Mounting
The limited warranty requires arbitration to resolve disputes on a case-by-case basis and,
where appropriate, specifying arbitration instead of jury trials or class actions.
4°
WARNING: Do not use this product in a location where it may be submerged in
water.
25 dB min
Universal pole mount, RocketM mount and
waterproof RF jumpers included
lift amplitude
200 km/h (125 mph)
VSWR max.
2. This equipment contains no operator-serviceable parts. Only a qualified service technician should
provide services.
Polarization
EN 302 326 DN2
Radio frequency connectors
wind load
1. Read, follow and save these instructions.

Declaration of conformity
Compliance
online resources
The antenna and transmitter must be installed to maintain a separation distance from
people and must not be co-located or used in conjunction with any other antenna or transmitter.
For the specific separation distance, see the quick start guide for your Rocket device (transmitter).
WEEE Compliance Statement
AMO-5G10 Quick Start Guide
Radio Frequency Exposure Warning
© 2022 Ubiquiti Inc. All rights reserved.