uComfy 8636 User manual

Electronic
Eye Massager
BATTERY OPERATED
UComfy™ Electric Eye Massager ITEM NO.8636
Manufactured abd Distributed by Emson® NY, NY 10001
©2012 All Rights Reserved. Made in China.

IMPORTANT SAFETY INSTRUCTIONS
Read all instructions carefully before using the unit.
- Use this product only when you are relaxingly seated or laid down. Do not use while
walking, running or bathing.
- Unit must be off before placing on the head.
- If you wear contact lenses, it is recommended to remove it.
- Do not use this unit if you have glaucoma, retinoschisis or any other serious eye diseases.
- Use only Alkaline Batteries inside the unit.
- To clean, use a damp cloth and wipe gently.
- Do not immerse in water.
- When finished, rest eyes on closed for 2 minutes.
- If the unit malfunctions or breaks down, Do not repair yourself. Instead, Call Customer
Service at [phone].
IMPORTANT - PLEASE READ
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
12
PARTS AND FEATURES
CONTROL PANEL
1
2
3
4
5
5
5
1. Airbag - air fills the
chambers of the mask,
applying slight pressure
2. Heat - delivers heat to the inner surface
of the mask for relaxing
3. Vibration - delivers vibration for relaxing
4. ON/OFF and TIME - Turns the unit ON and OFF.
Lets you set the massage timer (5/10/15 mins)
5. 5/10/15 min - massaging times for all 3
settings
6. Cycle selector - press to select through 7
massage modes:
1. Auto - will cycle through all 3 functions:
Airbag, Heat and Vibration
2. Vibration+Heat
3. Airbag+Vibration
4. Airbag + Heat
5. Vibration Only
6. Airbag Only
7. Heat Only (press again to advance to 1. Auto)
6

BATTERY INSTALLATION USAGE
3 4
BATTERY INSTALLATION
The massager operates using 4 AAA Batteries
(2 batteries per each battery compartment).
1. Open one of the Battery Compartments
located on both sides of the controller unit.
Lift cover. Refer to Diagram on right.
2. Insert 2 AAA Alkaline Batteries (not included)
inside the compartment. Observe polarity.
Do not mix old and new batteries.
3. Place the Battery Compartment cover back on.
4. Repeat for the other side.
5. When the massager starts operating sluggish,
it’s time to replace the batteries. Follow the above
directions to replace the batteries.
One of the sides of the
Battery Compartments shown.
4. Next, press ON/OFF - TIME button to select the massaging time. Choose between
5/10/15 minutes.
5. Slide the eye massager mask over your eyes. Adjust the elastic band for a proper fit.
6. During operation blue LED lights on the Eye Massager mask will flash. The selected
function icons on the control panel will be lit.
USAGE
1. Place the Eye Mask on. Place it around your forehead while making your selections.
2. Press the ON/OFF-TIME button to turn the Electronic Eye Massager on.
3. Press the button (in the center of the control panel) to select
1 of 7 massage modes:
1. Auto - will cycle through all 3 functions: Airbag, Heat and Vibration
2. Vibration+Heat
3. Airbag+Vibration
4. Airbag + Heat
5. Vibration only
6. Airbag only
7. Heat only (press again to advance to 1. Auto)

5 6
CARE AND STORAGE
7. When the massaging time had elapsed, the unit will automatically turn off.
Once the unit has turned off, keep your eyes closed for about 1-3 minutes.
8. If at any time you need to turn the unit OFF before the time is up, simply
press and hold the ON/OFF - TIME button during operation.
USAGE continued CARE AND STORAGE
USAGE
Before cleaning, always make sure to turn off the unit.
Do not wash the eye mask with water. Clean it by gently wiping it with a damp
cloth, or use a cloth dampened with rubbing alcohol.
Only use dry cloth to wipe the controller. Never use the damp cloth to clean the
controller.
Do not leave the unit under direct sunlight for extended periods of time.
Do not store the unit near the heat source.
If the unit malfunctions or brakes down, never try to repair it yourself,
consult a licensed electrician.