ULSee HC100 User manual

Google fit android app
Connect Health Watch to Join Health app for the first-time setup.
Health Watch will synchronize time with phone app automatically during initial setup,
so step counts, heart rates, and temperature data are updated correctly afterward
Bluetooth connection: After first successful connection, JOIN HEALTH app will
automatically search and connect with Health Watch whenever the app is turn on.
5.1. https://iot.ulsee.club/homebutler/sign-in
Sign In with JOIN HEALTH App Account
5.2. Home Page 5.3. Click on Google Fit Button
in Account Binding Section
5.4. Sign In with Google account 5.4.1 If there shows a warning window,
please click "Advanced" below
5.4.2 Then Click "Go to ulsee.club" 5.5. Add & See Your Heart Rate Info
to Your Data
5.6. Add & See Your Physical Info
to Your Data 5.7. Confirm Your Choices
5.8. Allow Permissions 5.9. Account Is Connected
Scan the following QR code to download the apps:
Join Health app, Google fit app, Alexa app.
2. Install Three Apps
1. Health Watch Basics Features
Quick Installation Guide For HC100
ULSee Health Watch
1. Power On: In the state of the shutdown, long press function key
over 3 seconds can make the device vibrate and boot.
2. Power Off: When the Health Watch is On, short press function
key few times to setting interface, then long press function key
enter setting mode. In this mode, short press function key few
times to the shutdown interface, then long press function key over
3 seconds to shutdown.
| Power On/ Off
Function Key
Wristatrap
Diplay Screen Adjustment Hole
3. Device Connection
4. JOIN HEALTH App Set up
5. Google Fit Binding
shutdown interface
JOIN HEALTH android app Alexa android app
JOIN HEALTH ios app Google fit ios app Alexa ios app
Malleolus Ulnaris
Left Hand
Ensor
For the first time, please take the Health Watch out and charge the equipment with the
corresponding charger. When charging, Health Watch will open automatically.
(Charge mode: Joint the USB-charging cable with Band at match point backsideand USB
port for charging. Charge voltage 5V)
| Charging Method
| Wearing Method
1. Best wear the Heath Watch behind malleolus ulnaris;
2. Adjust the size suitable for the size of wrists via Adjustment Hole, fasten wrist strap
buttons;
3. Sensor shall be close to skin avoiding moving.
4.1 Welcome page 4.3 Main Page:
My Devices
4.4 Scanned
Devices
4.2 Create an Account:
- Look for Verification Email in
Your Inbox
- Verify Your Account to Sign
In for the First Time

6. ULSee Home Butler Skill First Time Set Up 7. Alexa Routine Set Up
Download “ULSee Home Butler”
Create An Alexa Account & Sign In >> Click “More” >> “ Skill & Games” >> Search for “ULSee Home Butler” >> Click Enable to Use
Connect To ULSee Home Butler Skill
Sign In with Join Health App Account >> Alexa is looking for devices to connect >> Device is set up and ready
Check
Click “Devices” >> Wearable discovered show on the top. Clicked on View >> Discovered complete
Add action
Go To “ Skills” >> ”Your Skiils” >> “ULSee Home Butler” >> Alexa Will Open ULSee Home Butler
Choose Device
Select “Your Alexa Echo” >> Save >> Alexa Routine Set Up Completed
Create Routine
Click “More” >> “Routines” >> “Enter Routine Name” >> “When this happens” >> “ Smart Home” >> Choose Device >> “SAVE”