Control board overview
1. Micro USB port 2. Power jack 3. Power switch
4. SPI port 5. Serial number
TOUCH DEVELOPMENT KIT User Guide
1 32
4
5
1
2
3
4
Transformer
Array
Leap Motion®
camera module
Thank you for purchasing an Ultrahaptics TOUCH Development Kit (UHDK5). This user guide provides an
introduction to the contents in the box, how to get started and how to access support (if required).
Connect the hardware
1. Remove the security tape from the top and
bottom boards.
2. Connect the Leap Motion®camera module to the
computer using the Leap Motion®camera module
cable.
3. Connect the control board to the computer using
the Micro USB 2.0 cable.
4. Connect the power supply to the control board
power connector.
5. Connect the power supply to the mains power
source once all the other connectors have been
inserted (steps 1-3). Set the power switch to on.
Note: The TOUCH Development Kit (UHDK5) has been pre-loaded
with the required firmware.
What’s in the box?
• User guide
• Development Kit hardware platform (192-transducer
square array board, control board, frame structure
and Leap Motion®camera module)
• Leap Motion®camera module cable
• Micro USB 2.0 cable
• Multi-regional (US, UK and EU) power supply
• 'Compliance, Health & Safety and Warranty' booklet
