UltraLux RFWDB User manual

1
www.ultralux.bg
INSTRUCTIONS FOR EXPLOITATION
WIRELESS DOORBELL
Model: № RFWDB
By pressing the transmitter button, energy converting module
inside it convert the mechanical energy into electric energy and
then send the RF signal. When signal comes to the receiver it
starts working.
TECHNICAL SPECIFICATIONS
Specifications
Receiver
Transmitter
Supply Voltage
220-240 V AC/
50 Hz
Self-powered
Working Temperature
-10°C÷+40°C
Working range
70 m (open area)
RF Frequency
433 MHz
Power Consumption
(standby mode)
0.8 W
-
Dimensions
85/60/33 mm
79/44/33 mm
Ring Tones
38 polyphony
ring tones
-
Sound volume
3- sound levels
-
DESCRIPTION
1. LED light indicator;
2. Select a ring tone button;
3. Adjust sound volume button –three levels;
The receiver will turn back to factory settings when it is re-
plugged. It has no memory.
The receiver is paired with the transmitter as factory default
and additional transmitter/ receiver can ‘t be paired.
INSTRUCTIONS FOR INSTALLATION
Installation with screws
•Install the transmitter’s base on the wall with screws
and plugs.
•Carefully slide the transmitter down to the stop.
Installation with adhesive patch
•Clean the installation surface and the back of the
transmitter.
•Stick the transmitter to the installation surface by
adhesive patch.
Note: Before installation the transmitter, please run a test:
•Put receiver and transmitter on installation places.
•Close all doors and windows when you test.
•Push the transmitter. If the receiver does not sound,
please see problems and troubleshooting.
Attention:
•Avoid to installation the Transmitter/Receiver on
directly or near metallic surface as this may reduce
the operation range.
•When installing the transmitter onto a UPVC door
frame, always check the operating range before final
installation.

2
www.ultralux.bg
PROBLEMS AND TROUBLESHOOTING
IMPORTANT
•Do not use the receiver with rated supply voltages
other than 220 - 240 V AC / 50 Hz.
•Do not attempt to disassemble, repair or modify the
transmitter/ receiver.
•To ensure the cooling and proper operation, please do
not cover it during operation.
TAKING CARE OF THE NATURAL ENVIRONMENT
CLEANLINESS
•The product and its components are not harmful to the
environment.
•Please dispose the package elements separately in
containers for the corresponding material.
•Please dispose the broken product separately in
containers for out of usage electrical equipment.
Receiver does not
sound
1.Make sure the receiver is plugged in.
2.Check it is correct the supply voltage.
3.Unplug the receiver and wait for about
30 seconds, then re-plug it in.
LED light Indicator is off
Reduced range
1.Metal structures, including door
frames, can result in reduced
transmission range. Avoid mounting
transmitter / receiver on or near metal
structures.
2.Other electric equipment can cause
radio interference that affects your
receiver.
3.Walls, doors and ceilings will reduce
the range.
4. Unplug the receiver and wait for
about 30 seconds till the indicator light
off, then re-plug it in.