Unibright RF4RGBW User manual

LED indicator
Front side
Touch color wheel, touch to
select R/G/B color
R/G/B/W 4channels:Click to turn off/on the channel
Press and hold down to increase/decrease light intensity of each channel
Click to turn on/off all zones.
Click zone button(1/2/3/4),
Then press and hold down to
increase/decrease light
intensity of the chosen zone
Click to play / pause the
10 built-in effects,
Press and hold down to
speed up/down the
running effects
Click to choose zone, Press and hold down
to turn on/off corresponding zone
Press and hold down to save
colors/scenes; Click to recall
the saved colors/scenes
Back side
60.3 mm
52.0 mm
60.3 mm 52.0 mm
19.4 mm
Product Data
Output Signal
Power Supply
Power consumption
Operating temperature
Relative humidity
Dimensions
• Touch sensitive
• Glass interface(white & black)
• Compatible with all universal series RF receivers
• Radio frequency: 869.5/434MHz
• Control RGBW color
• Control 4 zones synchronously and separately
• Waterproof grade: Ip20
RF signal
100-240VAC
15 mA
0-40°C
8% to 80%
86x86x29.1mm
RGBW glass touch remote panel RF 4 zones
RF4RGBW
NL
AC Power input
RF4RGBW
PRI:
Uin=100-240VAC
Iin=15mA MAX
Out=RF Signal
TEMP RANGE:-20℃-+50℃
Button introduction
5
Product Size
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
Pair with RF receivers:
Turn on the wall
panel controller
How to delete the pairing:
Press and hold down “Learning Key” on the receiver for over 3 seconds until connected LED lights flicker twice,
which means the pairing is deleted successfully.
Click “Learning Key”
on RF receiver
LED lights connected with the
RF receiver will flicker once
The receiver is paired with
the remote successfully.
Touch the color wheel
Click a zone number on the
wall panel controller:1/2/3/4

Installation
Wiring diagram
AC 100-240V
AC Power
50/60Hz
UNI-BRIGHT BV – Belcrownlaan 13Q 2100 Antwerpen, Belgium
Tel : [phone] Fax: [phone] email: [e-mail]
www.unibright.be
VERSION 1 - 02/24
Save color/scene/mode:
Turn on the wall
panel controller
Recall the saved colors/scenes:
Immediately click any of the zone numbers
that you would like to save the color/scene to
The connected LED light with
DMX decoder/RF receiver will flash
Operation the buttons to
select a color /mode you like
Click one of the paired
zone numbers
Press and hold down button S until
the LED indicator change color
The color/scene is
saved successfully.
Turn on the wall
panel controller Click button S
Click any of the zone numbers you
would like to recall the scene/color
Click the zone number again
to recall the saved.
NL
RF4RGBW
PRI:
Uin=100-240VAC
Iin=15mA MAX
Out=RF Signal
TEMP RANGE:-20℃-+50℃