Telephone Operation
Redial
This unit redials up to 32 digits. To automatically
redial the last number you called:
1.Pick up the handset and wait for a dial tone.
2.Press the redial button.
Flash - Call Waiting
If the call Waiting tone sounds while you are on
acall-
Australia: Press ash then 2to switch between
callers.
New Zealand: Press the ash button to switch
between callers.
NOTE
For‘Call Waiting’ to operate you must
subscribe to this service through
your local telephone company.
If you do not have this service, then
pressing the ashing button during
a call may disconnect the caller.
Earpiece Volume
You may control the listening level with the
volume switch on the bottom of the handset. It
has 3 levels: lo, mid, and high.
Ringer Volume
You may control the ringer volume level with the
switch located above the touch tone pad on the
handset.
= ringer tone will be loud
= ringer tone will be low
= telephone will not ring
Troubleshooting Tips
Nodialtone.
•Pressandreleasethehookswitch.Check
the hook switch: Does it fully extend when
the handset is lifted from the cradle?
Phone doesn’t ring.
•MakesureRINGERswitch(locatedonthe
handset) is set to loud or low.
•Areyouusingtoomanyphonesonone
line?(ThetotalRENofallphonesonthe
same line should not be greater than the
maximumRENforyourcallingarea.REN
number is located on the cabinet bottom).
Other party cannot hear you.
•Makesurephonecordissecurelyplugged
in.
•Makesureextensionphonesareonthe
hook at the same time you’re using the
phone. It is normal for the volume to drop
when additional extension phones are
used at the same time.
•Thisisnormalfeedbackduetohandset
volume level being set to maximum.
General Product Care
To keep your telephone working and looking
good, follow these guidelines:
•Avoidputtingthephonenearheating
appliances and devices that generate
electrical noise (for example, motors or
uorescent lamps).
•DONOTexposetodirectsunlightor
moisture.
•Avoiddroppingandotherroughtreatment
to the phone.
•Cleanwithasoftcloth.
•Neveruseastrongcleaningagentor
abrasive powder because this will damage
thenish.
•Retaintheoriginalpackagingincaseyou
need to ship the phone at a later date.
Warranty only valid in the country of
original retail/sale.
PARTS COVERED: This warranty covers
for one (1) year, the Product and included
accessories.
STATEMENT OF REMEDY: In the event
that the Product does not conform to this
warranty at any time while this warranty is
in eect, the warrantor at its discretion, will
repair the defect or replace the Product and
return it to you without charge for parts or
service. This warranty does not provide for
reimbursement or payment of incidental or
consequential damages.
ThisEXPRESSWARRANTYisinaddition
to and does not in any way aect your
rightsundertheTRADEPRACTICESACT
1974(Cth)(Australia)ortheCONSUMER
GUARANTEESACT(NewZealand).
PROCEDURE FOR OBTAINING
PERFORMANCE OR WARRANTY: In the
event that the product does not conform
to this warranty, the Product should be
shippedordelivered,freightpre-paid,with
evidence of original purchase (e.g. a copy of
the sales docket), to the warrantor at:
UNIDEN AUSTRALIA PTY LIMITED
Service Division
345 Princes Highway
Rockdale,NSW2216
Fax (02) 9599 3278
www.uniden.com.au
UNIDEN NEW ZEALAND LIMITED
Service Division
EastTamaki,
Manukau2103
Fax (09) 274 4253
www.uniden.co.nz
One-year limited warranty
NOTE
Please keep your sales docket as it
provides evidence of warranty.
IMPORTANT: Evidenceoforiginal
purchase is required for
warranty service.
WARRANTOR: UnidenAustraliaPtyLimited
A.B.N.58001865498
UnidenNewZealandLimited
Warranty is only valid in the original
country of purchase.
ELEMENT OF WARRANTY: Uniden
warrants to the original retail owner for the
duration of this warranty, its FP1100 (herein
after referred to as the Product), to be free
from defects in materials and craftsmanship
with only the limitations or exclusions set
out below.
WARRANTY DURATION: This warranty
to the original retail owner only, shall
terminateandbeofnofurthereectONE
(1) year after the date of original retail sale.
This warranty will be deemed invalid if the
product is;
(A) Damaged or not maintained as
reasonable and necessary,
(B) Modied,alteredorusedaspartofany
conversion kits, subassemblies, or any
congurationsnotsoldbyUniden,
(C) Improperly installed,
(D) Repaired by someone other than an
authorizedUnidenRepairAgentfora
defect or malfunction covered by this
warranty,
(E) Usedinconjunctionwithany
equipment or parts or as part of a
systemnotmanufacturedbyUniden,
or
(F) WheretheSerialNumberlabelofthe
product has been removed or
damaged beyond recognition.