Uniden XDECT SSE06 User manual

1
XDECT SSE06
Accessory Handset
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz

2
When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
• This unit is NOT waterproof. DO NOT expose this unit to moisture.
• DO NOT expose this unit to rain.
• Do not use this product near water, for example, near a bath tub, wash
bowl, kitchen sink or laundry tub, in a wet basement or near a swimming
pool.
• Avoid using a telephone (other than a cordless type) during an electrical
storm. There may be a remote risk of electric shock from lightning.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
• The grant of a NZ Telepermit for any item of terminal equipment
indicates only that Telecom has accepted that the item complies with
minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of
warranty. Above all, it provides no assurance that any item will work
correctlyin all respects with another item of Telepermitted equipment
of a differentmake or model, nor does it imply that any product is
compatiblewith all of Telecom’s network services.
• The maximum volume setting of this telephone exceeds the Telecom
specified volume requirement. Telecom takes no responsibility for the
high volume available on this telephone, who believe this telephone is too
loud should contact the manufacturer at the website indicated on owner’s
manual warranty page.
• For telephone networks other than Telecom there may be a charge
incurred for local calls if the Insert 0 feature is on. Turn Insert 0 off.
• This equipment may not provide for the effective hand-over of a call to
another device connected to the same line.
General Notices for New Zealand Model:
Under power failure conditions this appliance may not operate. Please
ensure that a separate telephone, not dependent on local power, is available
for emergency use.
Important Notice

3
If any items are missing or damaged, contact your place of purchase
immediately. Never use damaged products!
Need help? Get answers at our website:
• www.uniden.com.au for Australian model
• www.uniden.co.nz for New Zealand model.
What’s in the Box?
SSE 06 accessory
handset with charger
Rechargeable Battery
Pack
AC adaptor
SSE06
Battery Cover
Belt Clip

4
INSTALLING YOUR HANDSET
1. Unpack the handset, battery pack, and
battery cover. If you need to remove the
cover, press in on the notch and slide
the cover down and off.
2. Line up the battery connector with the
jack inside the handset; the connector
only fits one way.
3. Push the connector in until it clicks
into place; tug gently on the wires
to make sure the battery is securely
connected.
4. Replace the battery cover and slide it into place.
5. Use the AC adaptor to connect the power jack on the charger to a regular
indoor (240V AC) power outlet.
6. Place the handset in the charger with the display facing forward. If the
display doesn’t light up, reseat the handset or connect the charger to a
different outlet.
Charge the Battery
#Charge the handset completely (about 15 hours) before using it.

5
If.. Try..
xyou don’t hear a dial tone the
display shows Registration Failed
xmaking sure the handset is fully
charged, then try again.
Test the Connection
This handset is designed for use with Uniden’s SSE35 and SSE37 bases.
Compatible Bases
REGISTERING TO A BASE
The accessory handset won’t work until you register it to a compatible
Uniden cordless phone!
Registration Methods
Does the handset fit in the base cradle?
Yes Place the handset in the base. The display should say
Registering.
No Does the base have an LCD display?
Yes On the base, press MENU to open the menus and
then scroll to Register Accy. Press OK.
On the handset, press and hold #DND until the
handset display shows Registering (about 2
seconds).
No On the base, press and hold FIND HS when the
phone is in standby (about 5 seconds).
On the handset, press and hold #DND until the
handset display shows Registering (about 2
seconds).
#After about 30 seconds, the handset display should say Registration
Complete.
Pick up the handset and press TALK/FLASH. Make sure you get a dial tone.
(Press END/CLEAR to hang up.)

6
Parts Number Input Voltage Output Voltage
AAD-600S(M) 100-240V AC, 50/60Hz 9V DC @ 210mA
Type Capacity Talk time Standby Time
BT-694 or
BT-694s
BT- 694n
650mAh or 500mAh
or 400mAh
about 10 hours about 7 days
IMPORTANT INFORMATION
AC Adaptor
Battery Information
1. All features and operation for the handset are described in the owner’s
manual for the base.
2. Owner’s Manual for all Uniden phones are available on our website for
free downloading.
• Use only the supplied AC adaptors.
• Use the proper adaptor for the base and any charger.
• Do not place the unit in direct sunlight or subject it to high
temperatures.
• Replace the battery when the talk or standby time becomes noticeably
reduced. For replacements, visit the online shop on our website (see the
front cover).
• When the battery gets low, the handset beeps and shows a low battery
alert; put the handset in the cradle for recharging.

7
ONEYEAR LIMITED WARRANTY
Terms of Warranty: Uniden Aust/NZ warrants to the original retail
purchaser only that the SSE06 (“the Product”), will be free from
defects in materials and craftsmanship for the duration of the warranty
period, subject to the limitations and exclusions set out below.
Warranty Period: This warranty to the original retail purchaser is only
valid in the original country of purchase for a Product first purchased
either in Australia or New Zealand and will expire one (1) year from the
date of the original retail sale. If a warranty claim is made, this warranty
will not apply if the Product is found by Uniden to be:
A. Damaged or not maintained in a reasonable manner or as
recommended in the relevant Uniden Owner’s Manual;
B. Modified, altered or used as part of any conversion kits,
subassemblies or any configurations not sold by Uniden Aust or
Uniden NZ;
C. Improperly installed contrary to instructions contained in the relevant
Owner’s Manual
D. Repaired by someone other than an authorized Uniden Repair Agent
in relation to a defect or malfunction covered by this warranty; or
E. Used in conjunction with any equipment, parts or a system
notmanufactured by Uniden.
Parts Covered: This warranty covers the Product and included
accessories.
User-generated Data: This warranty does not cover any claimed loss of
or damage to user-generated data (including but without limitation phone
Satisfactory evidence of the original purchase is required for warranty
service. Please refer to our Uniden website for any details or warranty
durations offered in addition to those contained below.
The warrantor is either Uniden Australia Pty Limited ABN 58 001 865 498
(“Uniden Aust”) or Uniden New Zealand Limited (“Uniden NZ”) as the
case maybe.
XDECT SSE06
Important:
Warrantor:

numbers, addresses and images) that may be stored on your Product.
Statement of Remedy: If the Product is found not to conform to this
warranty as stated above, the Warrantor, at its discretion, will either
repair the defect or replace the Product without any charge for parts or
service. This warranty does not include any reimbursement or payment
of any consequential damages claimed to arise from a Product’s failure to
comply with the warranty. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure. This warranty is in addition
to and sits alongside your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER GUARANTEES
ACT (New Zealand) as the case may be, none of which can be excluded.
Procedure for Obtaining Warranty Service: Depending on the
country in which the Product was first purchased, if you believe that
your Product does not conform with this warranty, you should deliver
the Product, together with satisfactory evidence of your original
purchase (such as a legible copy of the sales docket) to Uniden at the
addresses shown below. You should contact Uniden regarding any
compensation that may be payable for your expenses incurred in making
a warranty claim. Prior to delivery, we recommend that you make a
backup copy of any phone numbers, images or other data stored on
your Product, in case it is lost or damaged during warranty service.
UNIDEN AUSTRALIA PTY LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Phone number: 1300 366 895
Email: custser[email protected]
UNIDEN NEW ZEALAND LTD
Service Division
150 Harris Road, East Tamaki
Auckland 2013
Phone number: [phone]
Email: ser[email protected].nz
©2012 Uniden Australia Pty Ltd/Uniden New Zealand Lt
d
Printed in Vietnam U01UU281EZZ(0)