Unitek Miyachi STAR NX-1001 User manual

USER’S MANUAL
No. 990-086
REV. A
UNITEK MIYACHI
CORPORATION
MICROPULL V MANUAL INSERT
STAR NX-1001 115VAC
KX-P1150
These printers may be used on the following product:
Model MP5 Stock No. 6-105-01-01
UNITEK MIYACHI Corp.
1820 S. Myrtle Ave.
Monrovia, CA 91017-7133
[phone] Fax: [phone] Printed June 19, 1995

HF2 ADVANCED SERIAL DATACOM INITIAL SETUP PROCEDURE
March 15, 1995, REV. A Page 2
- 2 -

- 20 -
This insert to the MICROPULL V Manual replaces pages 20 through 22 (Section 6.00 through section 6.07.4)
when the MP5 is used with Star NX-1001 printer.
6. INITIAL SETUP PROCEDURE
6.1 BEFORE CHANGING THE POSITION OF THE MP5 ON THE BENCH, ALWAYS REMOVE THE
DEVICE HOLDER FROM THE BASEPLATE.
6.2 Connect the Keypad to the Keypad Receptacle on the rear of the MP5.
6.3 Connect the MP5 to an outlet of the proper line voltage.
6.4 PRINTER SETUP - Detailed instructions for printer installation and operation are provided in the
printer’s User’s Guide and Technical Reference Manual which are included with the printer. Set up the
printer as explained in the printer manual.

- 21 -
6.5 PRINTER CONNECTION - Use the standard male-to-male RS232 Cable supplied with the MP5.
6.5.1 Connect one end of the cable to the RS232 Serial Port on the rear of the MP5.
6.5.2 Connect the other end of the cable to the Serial Connector of the Serial-Parallel Converter (SPC-8K).
Serial-Parallel Converter (SPC-8K)
6.5.3 Set the DIP switches on the Serial-Parallel Converter (SPC-8K) as shown below:
DIP SWITCH SETTINGS
Switch Setting Description
1 ON 8 data bits
2 ON No parity
3 ON DTR mode
4 ON
5 ON Odd parity
6 OFF
7 ON 1200 Baud Rate
8 ON

- 22 -
6.5.4 Connect the Parallel Connector of the Serial-Parallel Converter (SPC-8K) to the Interface Connector of
the Star NX-1001 printer.
6.6 PRINTER POWER CABLE CONNECTION - Connect the printer power cable to an outlet of the
proper line voltage (usually 115VAC).
6.7 Switch the Printer Power Switch to “ON.”