Universal Furniture 219210-21SF-21R User manual

Page 1of 2
INSTRUCTION SHEET
219210-21SF-21R /219220-22SF-22R/23R
Spencer Storage Bed Queen, King
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Footboard
1pc
B
Footboard Support Leg
2pcs
C
Headboard
1pc
D
Side Rails
2pcs
E
Center Rail
3pcs
F
Center Support Leg
3pcs
G
Support Panels
4pcs
H
Hardware Pack
1bag
NOTE: The 21922R and 21923R King and Cal King beds have 6 center support legs
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Put footboard (A) upright down on a flat smooth surface to avoid damage or being scratched.
Screw footboard support legs (B) into footboard (A) by hand.
Step 3: Turn footboard (A) upright, take off drawers from footboard.
Step 4: Connect side rails (D) with headboard (C) and footboard (A) by wood dowels (5) and tighten
with Phillip head bolts (1), spring washers (2) and flat washers (3) by using wrench 4.
Step 5: Screw center support legs (F) into center rails (E) by hand. Attach center rails (E) to side rails
(D) with long wood screws by screw driver (Not provided.) Put drawers into footboard as
shown..
Step 6: Lay out slat rolls (G) onto side rails (D) and tighten with short wood screws (7) by using
screw driver (not provided).
Assembly is now complete.

Page 2of 2
INSTRUCTION SHEET
219210-21SF-21R /219220-22SF-22R/23R
Spencer Storage Bed Queen, King