Universal Furniture Universal EXPLORE HOME 788-966 User manual

INSTRUCTION SHEET
788-966
Entertainment Console
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Console Top
1pc
B
Side Leg
4pcs
C
Center Leg
1pc
D
Glass Door
4pcs
Hardware pack
1bag
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: put the dresser top (A) upright down on a soft and smooth surface to avoid damage or being
scratched. Then attach the legs (B & C) to the table top (A) with phillip head bolts (1), spring
washers (2) and flat washers (3) using wrench (4). Tighten all the bolts and turn it upright.
Step 3: Put the pad (6) and bracket (5) onto the top and bottom of the glass door (D) as below shown.
Note : It is best for two or more persons are involved.
Assembly is now complete.
4
1
3
2
1
2
3
4
Q'TYHARDWARE LIST(E)
PHILLIP WRENCH
SPRING WASHER
FLAT WASHER
WRENCH
PAD
"U" BRACKET
5
6
87*19.2.5mmT
10PCS
5/16"1"
5/16"*13*2mm
5/16"*19*2mm
10PCS
10PCS
1PC
8PCS
8PCS
40*24*16mm
43*47*2mm
Step 2
AB
C

INSTRUCTION SHEET
788-966
Entertainment Console
65
DStep 3 5
6