Universal Furniture WINDSOR CHAIR 795-636 User manual

GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
795-636
WINDSOR CHAIR
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Chair Back
1 pc
B
Seat Frame
1 pc
C
Left Leg
1 pc
D
Right Leg
1 pc
E
Side stretcher
2pcs
Assembly Procedure:
Caution: Please do not over-tighten bolts during assembly.
Note: First read the chair leveling instructions. This is an additional assembly instruction sheet found
inside the carton.
Step 1: Place Seat Frame (B) on a flat, soft, smooth surface with holes facing up. Attach Front Legs
(C&D) to Seat Frame (B) using (2) bolt + spring washer + flat washer. Tighten with wrench
(5). Do not fully tighten.
Step 2: Place Chair Back (A) on a soft, smooth surface with holes facing up. Align and insert side
stretcher (E) to the Chair Back and Front Leg. Attach Seat Frame (B) to Chair Back (A) using
(1) bolt + spring washer + flat washer, with wrench (5) to install it. Do not fully tighten.
Step 3: Attach rear corner blocks of Seat Frame (B) to Chair Back (A) using (3) bolt + spring washer
+ flat washer. Tighten with wrench (5). Do not fully tighten. Secure side stretchers (E) to Front
Legs (C&D) and Chair Back (A) with wood screws (4), using a Phillips head screw driver (not
included).
Step 4: Make sure the chair is level and tighten all bolts completely using the wrench supplied.

GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
795-636
WINDSOR CHAIR
Assembly is now complete.