Universal Furniture 558-825 User manual

INSTRUCTION SHEET
558-825
Carlton End Table
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Table Top
1pc
B
Front post
2pcs
C
Side post
2pcs
D
Bottom Panel
1pc
E
Hardware Pack
1bag
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware. Make sure
the quantity of each is correct.
Step 2: Put the parts on a soft and smooth surface to avoid damage or being scratched. Insert the
wood dowels (1) into the predrilled holes on the posts (B, C) for position. Then attach the
posts (B, C) to the table top (A) with allen head bolt (3, 5) using allen wrench (2, 4) from
hardware pack (E).
Step 3: Attach the bottom panel (D) to the table top (A) with allen head bolt (3, 5) using allen wrench
(2, 4) from hardware pack (E). Then turn it upright.
Assembly is now complete.
1
2
3
4
5
10*40mm
70*30*4mm
1/4"*1"
70*30*5mm
4PCS
1PC
8PCS
1PC
8PCS
Q'TY
HARDWARE LIST(E)
WOOD DOWEL
ALLEN WRENCH
ALLEN HEAD
BOLT
ALLEN WRENCH
ALLEN HEAD
BOLT 5/16"*2"

INSTRUCTION SHEET
558-825
Carlton End Table
1
3
2
5
4
Step 2
B
B
C
C
3
25
4
Step 3
D