Universal Furniture 932-816 User manual

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Table Top
1 pc
B
Shelf
1 pc
C
Bottom Panel
1 pc
D
Side Frame
2 pcs
E
Stretcher
2 pcs
F
Hardware Pack
1 bag
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Attach the bottom panel (C) to the side frames (D) with long bolts (1), lock washers (3) and
flat washers (2). Attach the shelf (B) to the side frames (D) with short bolts (4), lock washers
(3) and flat washers (2). Tighten all the bolts by Allen wrench (5)
Step 3: Attach the stretchers (E) to bottom panel (C) with dowels (7) and long screws (6) with a
Philips head screwdriver (not provided) as shown.
Note: The stretchers are half-lapped that can be secured with the short screw (8). The ends
without labels should be attached to bottom panel (C). The ends labeled as UP should be
attached to table top (A).
Step 4: Put the table top (A) face down on a soft and smooth surface to avoid damage or being
scratched. Locate the stretchers (E) to table top with dowels (7) and secure stretchers with
long screws (6) by a Philips head screwdriver (not provided) as shown. Secure the side
frames (D) to table top (A) with long bolts (1), lock washers (3) and flat washers (2). Tighten
all the bolts by Allen Wrench (5).
Step 5: Turn the table upright.
Assembly is now complete.
INSTRUCTION SHEET
932/994/995/996-816
Sofa Table