Universal Furniture 450260 User manual

GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
450260/26F/26R(27R)
New Bohemian Bed
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Headboard
1pc
B
Side rails
2pcs
C
Footboard
1pc
D
Slat panels
3pcs
E
Support Legs
6pcs
F
Hardware bag
1pc
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Attach side rails (B) to the Headboard (A) and Footboard (C) with nut (1),spring washer (2),
Semicircle metal plate (3) and bolt (5) using wrench (4) from the hardware bag (F).
Step 3: put slat panels (D) onto the inside notches of side rails (B), tighten them with screws (6) by
screwdriver (not provided). Screw center support legs (E) into slat panels (D).
Assembly is now complete.

GOOD, AFFORDABLE, SMART DESIGN.
INSTRUCTION SHEET
450260/26F/26R(27R)
New Bohemian Bed
A
B
BC
4
1
2
3
5
Step 2
6
D
DD
E
Step 3