Universal Furniture Universal EXPLORE HOME 805-816 User manual

INSTRUCTION SHEET
805-816
Console Table
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
Description
Qty.
A
Table Top
1pc
B
Shelf
1pc
C
Back Leg, Right
1pc
D
Back Leg, Left
1pc
E
Front Leg
2pcs
F
Hardware pack
1bag
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Put the all the parts on a soft and smooth surface to avoid damage or being scratched. Then
attach the legs (C & D &E) to the table top (A) and shelf (B) with phillip head bolts (2), spring
washers (4), flat washers (5), wood dowels (6), wood screws (7) and nuts (3) using wrench
(1), see below.
Note 1 Adjustable levelers are provided on each table leg. When assembly is complete, check to
ensure the table is sitting level on the floor. If the table is not level, turn one or if needed
more of the adjustable levelers clockwise until the table sits evenly on the floor.
Assembly is now complete.

INSTRUCTION SHEET
805-816
Console Table
45
3
1
6
12
5
47
6
DOWN
UP
FLAT WASHER
SPRING WASHER
PHILLIP HEAD BOLT
WRENCH
HARDWARE LIST(F) Q'TY
5/16"*23*2mmT
5/16"
12mm
5/16"*2-1/4"
8PCS
4
2PCS
3
1PC
6PCS
2
1
5
6
7
5/16"
8PCS
NUT
10*40MM
6PCS
#8*1-1/4 "
2PCS
WOOD DOWEL
WOOD SCREW
6
Step 2
A
C
B
E
D
6

INSTRUCTION SHEET
805-816
Console Table