7?A<
>
Features and Bene its
%+))%!+ &%%/+%F%- 7>A<
The MRF-350i receives RF (radio requency) signals via the RFX-250i RF Sensor.
The RFX-250i displays RF inter erence via a bright red LED, which lickers when
inter erence is present. Simply relocate the RFX-250i out o the inter erence.
/'%%0 %7>A< %*&)* %$&+)*
The MRF-350i can power up to three RFX-250i RF Sensors connected in parallel to
the RF Input connector.
) #,+',++*)%#%',+*
The MRF-350i is equipped with adjustable IR line outputs, each output can be
individually matched to rear panel IR inputs on any component that is designed
to be operated by a standard IR repeater. The outputs utilize a 3.5mm jack.
'& +%(, '$%+&+ &%* +%+ #&$'&%%+*
Each MSC System remote is “addressable.” They can be programmed to speci ically
control components in a particular room by installing a base station at each
location. In operation it’s simple: when you select a device located in the Den,
the MX series remote only sends commands to the Den. When you select a
device located in the Family Room, the MX-3000i only sends commands to it.
%#7?A< %&%+)&#%))0&%+ #&$'&%%+*
&)%+ #&%*&,#+ &%)$'6+) /. +)
Each MRF-350i has six “addressable” IR Line Outputs. For example, you can control
up to six identical TV’s with one MRF-350i or route volume commands or a
speci ic zone to a particular zone IR input on a multi-zone preamp. I you have
more than six identical components or zones, up to 15 additional MRF-350is can
be installed to control them (thus allowing up to 90 identical components or
zones in one house).
F%',+&)0'*&)F'+)0*+$*
The MRF-350i rear panel IR input will relay IR Data rom IR repeaters or
Multi-Zone Keypads to all IR line outputs (does not support IR routing). The 5V,
100 milliamp output will directly power some brands and models o keypad
directly.
Parts Guide
1 - RFX-250i RF Sensor with integrated
antenna
1 - Mounting plate or RFX-250i
1 - MRF-350i Base Station
1 - Mounting Plate or wall mounting the
MRF-350i
8 - Screws or wall mounting the two
mounting plates
1 - 9V-300mA Power Supply
6 - Visible Flashers with 10 oot plug in cables.
6 - Extra sel adhesive pads or Emitters
1 - 12’Connecting Cable
1 - Adjustment Tool (Screwdriver or RF ID
and IR level adjustment)
2 - Depluggable screw connectors or RF con-
nections when extending wires.
