Update International WRU-35 User manual

1
WRU-35 Assembly Guide Book
(2012.05.09)

2

3
a. Insert four # A screws to upper and bottom
edges
b. Insert four # D wood pegs to upper and bottom
edges highlighted with
c. Insert eight # B caps to side edges highlighted
with
UP
# 1 Back Panel

4
a. Insert eight # A screws w/ rubber grip on # 4
panel and do the same on # 7 panel highlighted
with
d. Insert five # D wood pegs on # 4 panel and do the
same on # 7 panel highlighted with
UP
# 4 & # 7 Side Panel
c.
Attach # 9 S/S blocking panel (highlighted with
) to # 4 panel using three # C screws and do
the same on # 7 panel
b.
Insert one # A screw w/o rubber grip on # 4 panel
(highlighted with ) and do the same on # 7
panel

5
Insert two # B screw caps highlighted with
on # 5 wood front blocking panel
# 5 & 10 Blocking Panels
Connect # 10 S/S front
blocking panel to # 5 wood
front blocking panel using
three # C screws

6
Insert six # B screws highlighted
with on # 2 top panel
(longer)
# 2 Top Panel (longer)
Attach three corner braces
highlighted with to # 2
panel using # E screws
Front

7
Insert six # B screw caps highlighted
with on outside of # 3
bottom panel (shorter)
# 3 Bottom Panel (shorter)
Flip over the bottom
panel and attach three corner
braces highlighted with
to inside of # 3 panel using # E
screws
Front

8
Check if # B screw on # 2, # 3,
or # 5 panels has its pointer
facing toward the edge )

9
Attach #2 and #3
panels to # 1 panel by
tightening # B screw
cap highlighted with
180 degree
clockwise to lock
Secure corner braces
Highlighted with
by using # E screws

10
Attach #4 panel to the right
of the panel set assembled
in previous step; tightening #
B screw cap highlighted with
180 degree clockwise
to lock
Secure corner braces
Highlighted with
by using # E screws

11
Flip over panel set
assembled in previous step;
attach # 6 and # 5 panel to
# 4 panel; attach # 7 as
shown; then tightening all #
B screw cap highlighted
with 180 degree
clockwise to lock.
Secure corner braces
Highlighted with
by using # E screws

12
Screw in the hinges
highlighted with
to # 8 door then attach # 8
door to # 4 panel with four
# E screws
If # 4 panel is missing drill holes
for # 8 door; use hinge hole
drilling template to pre-drill
holes on # 4 panel before
assembling.

13
Mission Complete !!