UPPAbaby ALTA User manual

USA
UPPAbaby, 60 Sharp Street, Ste 3, Hingham, MA 02043 | www.uppababy.com | 1.844.823.3132
Australia
Coolkidz Australia Pty Ltd, 29 Taunton Drive, Cheltenham, Victoria, Australia 3192 | www.uppababy.com | 1300 722 302
Model 0192 | Version 3
All rights reserved. © 2015 UPPAbaby. UPPAbaby and all associated logos are trademarks. All product specifications are correct at time of print.
UPPAbaby reserves the right to change anything at any time without prior notice. Color representation is as close as print processes allow.
Not all colors available at all retailers.
102015
0192_ALTA_Instructions_V3.indd 2-3 10/21/15 10:59 AM

Warnings + General Safety Information 2
Cleaning + General Maintenance 4
Parts List 5
Stroller Assembly 6
Stroller Operation 8
Limited Warranty 15
TABLE OF CONTENTS
Please read these instructions carefully prior to assembly and use.
0192_ALTA_Instructions_V3.indd 1-1 10/21/15 10:59 AM

23
WARNINGS + GENERAL SAFETY INFORMATION WARNINGS + GENERAL SAFETY INFORMATION
TO AVOID INJURY OR DEATH:
ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS STATIONARY.
•DO NOT LEAVE CHILDREN UNATTENDED.
•SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
•DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.
•MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU
ADJUST THE STROLLER.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Please read this manual carefully before using this stroller. Failure to
follow instructions properly may result in serious injury to your child.
• The UPPAbaby ALTA stroller is suitable from 6 months and designed to
accommodate a child up to a weight of 23 kg (50 lbs) and a height of 101 cm
(40"). Excessive weight may cause a hazardous unstable condition to exist.
The product will become unstable if the manufacturer’s recommended load
is exceeded.
• Ensure that all the locking devices are engaged before use.
• Bumper bar must be attached at all times.
• DO NOT use the bumper bar without bumper bar cover.
• Any load attached to the handle aects the stability of the stroller.
• Unit may become unstable if the manufacturer’s recommended load
is exceeded, or if a parcel bag, accessory, or rack other than that
recommended by the manufacturer is used or hung from the unit.
• It is unsafe to use accessories other than those approved by UPPAbaby.
• Extreme care should be taken if the stroller is used on stairs or an
escalator.
• The stroller should not be used near an open fire or exposed flame.
• Maximum weight for the storage basket is 11.3 kg (25 lbs).
• Always use the crotch strap in combination with the waist belt and
shoulder belts.
• NEVER leave safety harness connected when not fitted to a child in
the stroller, as this may create loops that could cause a strangulation
hazard.
• The brake must be locked while taking the child in or out of the
stroller, and when parked.
• The stroller is designed for use on flat or gently sloping surfaces and
may be unstable on higher sloping and uneven surfaces and could tip
over if on sloping, unstable or uneven surfaces.
• Always use the tether strap to prevent the stroller from rolling away.
• Children and adults should be clear of moving parts while making
stroller adjustments. If not properly executed, damage to fingers or
extremities may occur when opening or closing the stroller frame.
• The canopy for the seat is not intended to retain the child.
• Make sure latch on left side of stroller is properly engaged after
stroller is folded. Carry grip on side of stroller should be used for ease
of transport.
• Complies with AS/NZS 2088:2013.
WARNINGWARNING
0192_ALTA_Instructions_V3.indd 2-3 10/21/15 10:59 AM

45
Stroller
Frame
Telescoping
Handlebar
Basket
Front
Wheels
Canopy
Extendable
Sunshade
PARTS LIST
Back
Wheels
Rain Shield Insect Net
Bumper Bar
with Cover
CLEANING:
• Clean frame with a damp cloth and a mild detergent; dry thoroughly. DO NOT use abrasives.
• If the stroller frame parts have been exposed to salt water we recommend that they be rinsed
with fresh (tap) water as soon as possible to avoid corrosion. Always dry frame if wet.
• All fabrics are removable.
• Spot clean or hand wash in cold water with mild detergent. Dry flat and away from direct
sunlight before re-use or storage. DO NOT bleach, iron or dry clean.
• To extend the life of your ALTA’s fabric, keep it clean and do not leave it in direct sunlight for
long periods of time.
• DO NOT fold or store the ALTA if it is damp or wet, nor store in a damp environment.
MAINTENANCE AND REPAIR:
• This stroller requires regular user maintenance. Regularly check all connecting hardware (rivets,
screws, etc.) for tightness and security.
• Inspect your ALTA periodically. Seek prompt repairs, replacing worn or broken parts as needed.
Check all safety devices, locks and harnesses for correct and secure operation. Never continue
to use a product that is structurally unsound.
• Only UPPAbaby replacement parts should be used. It may be unsafe to use parts supplied by
another manufacturer.
• Do not make any alterations or modifications to the stroller with products not supplied by the
manufacturer as this may cause instability or structural damage not covered under warranty.
• Please contact Customer Service with any repair questions.
UPPAbaby reserves the right to make design changes and improvements
to any of our products as part of our commitment to innovation.
CLEANING + GENERAL MAINTENANCE
CLEANING ALL REMOVABLE FABRICS
Spot clean or hand wash gently
in cold water with mild detergent.
Dry flat and away from direct
sunlight before re-use or storage.
DO NOT bleach,
iron or dry clean.
Tether Strap
0192_ALTA_Instructions_V3.indd 4-5 10/21/15 10:59 AM

67
To Install Back Wheels: Slide wheel post into housing
until it locks into place.
STEP 1: Insert metal posts into bumper bar
attachment slots found on both sides of seat.
To Remove Back Wheels: Pull tab down on bottom
of fork and slide wheel out .
STEP 2: To remove, press button at bottom of plastic
housing and lift bumper bar out.
STROLLER ASSEMBLY
INSTALLING FRONT WHEELS
INSTALLING BACK WHEELS
ATTACHING/REMOVING THE BUMPER BAR
To Remove Front Wheels: Push button located
on the inside of the front fork and slide wheel o.
To Install Front Wheels: Slide wheel post into housing
until it locks into place.
STEP 1: Pull latch back with thumb to release locking
mechanism.
To Attach Canopy: Snap each side of canopy
attachment to seat frame above plastic ring.
STEP 2: Pull handle upward until frame locks open
as shown.
To Adjust Canopy Height: Slide canopy attachment
simultaneously up or down the seat frame, in
between two plastic rings, for desired height.
STROLLER ASSEMBLY
UNFOLDING THE STROLLER
CANOPY INSTALLATION AND OPERATION
NOTE: Bumper bar should not be used without bumper bar cover.
0192_ALTA_Instructions_V3.indd 6-7 10/21/15 10:59 AM

89
STROLLER OPERATION
OPERATING THE SEAT
To Attach Seat: Lower seat onto frame in forward or reverse position and press down until it clicks into place.
Pull up on seat to ensure it is locked to frame.
To Remove Seat: Simultaneously push down both
release buttons and lift seat from frame .
To Recline Seat: Engage button on seat back and tilt
seat to desired position. Release button to lock in
one of five preset positions.
NOTE: DO NOT use upright position for infants less than six months old, unless using Infant Snugseat.
Use the most reclined position and gradually reposition seat more upright as child is able to support
his or her head without assistance.
SETTING THE SWIVEL/LOCKING SYSTEM
SETTING THE BRAKE
ADJUSTING HANDLE HEIGHT + LEG REST
STROLLER OPERATION
To Lock Wheel Swivel: Push button down to lock.
Lock wheel swivel if traveling through rough terrain
or sand.
To Unlock Wheel Swivel: Slide button up.
To Lock Brake: Brake is located in center of rear
crossbar. Push down pedal with foot to lock.
To Release Brake: Either push front edge of
pedal forward or use foot to lift pedal up.
To Adjust Handle: Squeeze button at top and slide
handle to one of three desired positions suited to
user height and comfort.
To Adjust Leg Rest: Simultaneously push
buttons on sides of leg rest and rotate to
desired position.
0192_ALTA_Instructions_V3.indd 8-9 10/21/15 10:59 AM

10 11
Proper Installation of Rain Shield Proper Installation of Bug Shield
STEP 2: Detach grey adjustment clip from harness
attachment loop.
STEP 2: Reattach clip to the desired harness loop.
STROLLER OPERATION
CORRECT ATTACHMENT OF ACCESSORIES
ADJUSTING SHOULDER HARNESS HEIGHT
NOTE: Use loop location above child’s shoulder line, or closest to child’s shoulder.
WARNING: Use 5-point harness at all times to restrain child while in stroller. Adjust harness to fit child securely.
To Lock the Harness: Slide belt ends into center lock
housing until it clicks together.
To Unlock the Harness: Depress grey button at center
and pull apart.
STROLLER OPERATION
OPERATING THE SEAT HARNESS
CORRECT USE OF TETHER STRAP
NOTE: A tether strap is fitted to this stroller. Place the
loop over left wrist when using the stroller.
0192_ALTA_Instructions_V3.indd 10-11 10/21/15 11:00 AM

12 13
STROLLER OPERATION
STEP 1: Unfasten elastic loops from lower footrest.
STEP 3: Unsnap nylon webbing from frame.
STEP 2: Unzip retainer pocket located on underside
of seat.
STEP 4: Remove seat fabric from frame. Reverse
process when putting fabric back on.
REMOVING FABRICS FROM SEAT
NOTE: Reverse steps when replacing seat fabric.
STROLLER OPERATION
STEP 1: Activate brake to prevent stroller from rolling
forward while folding.
STEP 3: Place index fingers on both slide release
triggers and slide upward until frame begins to fold.
STEP 5: Continue to fold stroller until latch on left
side has engaged. Stroller will stand when folded.
STEP 2: Engage button on top of handle bar and
extend to highest position.
NOTE: Handle must be in highest position for stroller
to stand when folded.
STEP 4: Once stroller begins to fold, hold handle bar
with right hand and reposition left hand onto back leg.
STEP 6: Use carry grip for easy transport.
FOLDING THE STROLLER
NOTE: When folding frame with seat attached, seat must be in forward facing and upright position.
0192_ALTA_Instructions_V3.indd 12-13 10/21/15 11:00 AM

14 15
Your UPPAbaby stroller is warranted to be free from any manufacturing defects for a
period of 2 years from the date of purchase under normal use and in compliance with
the operating instructions.
This warranty is not transferable and extends only to the original retail purchaser and
is only valid when supplied with proof of purchase. PLEASE RETAIN PROOF OF
PURCHASE FOR THIS LIMITED WARRANTY.
The warranty is valid only in the original country of purchase. This warranty is subject
to the conditions set forth by country in which the items were purchased. Conditions
may vary. UPPAbaby will not ship replacement or repair parts out of the country
of purchase.
UPPAbaby will provide replacement parts or conduct repairs as determined fitting by
the company. UPPAbaby reserves the right to exchange item with a replacement part.
Some parts may be replaced with newer model parts as the stroller is improved over time.
Please NOTE that a repair issue will NOT be covered by this warranty if:
• The issue is caused by misuse or poor maintenance. Please refer to this instruction
booklet for guidance on stroller use and maintenance.
• Damage is caused by improper installation of UPPAbaby parts and/or accessories.
Please refer to this instruction booklet for guidance on stroller assembly and use.
• Damage is corrosion, mold or rust caused by lack of maintenance or service.
• Damage is due to general wear and tear, which is the result of everyday use or negligence.
• Damage is caused by sun intensity, sweat, detergents, damp storage or frequent washings.
• Repairs or modifications are carried out by a third party.
• Stroller is purchased from an unauthorized retailer. Approved retailers are listed on our
website at www.uppababy.com.
• Stroller is second-hand.
• Stroller is damaged as a result of an accident, airline or freight damage.
UPPAbaby reserves the right to determine if warranty terms and conditions have been met.
Please contact your local distributor if you have any questions regarding warranty.
CUSTOMER SERVICE
COUNTRY CONTACT TELEPHONE WEBSITE
US 60 Sharp Street Hingham, Suite 3, MA 02043 1.844.823.3132 uppababy.com
AUSTRALIA
Coolkidz Australia Pty Ltd
29 Taunton Drive, Cheltenham
Victoria, Australia 3192
1300 722 302 uppababy.com
LIMITED WARRANTYSTROLLER OPERATION
REMOVING FABRICS FROM CANOPY
STEP 1: Unscrew hinge on one side of canopy.
STEP 3: Remove plastic frame from hinge by sliding
it upward.
STEP 2: Remove hinge from aluminum frame.
STEP 4: Remove frame from canopy by sliding fabric
o of both aluminum and plastic frames.
NOTE: Reverse steps when replacing canopy.
0192_ALTA_Instructions_V3.indd 14-15 10/21/15 11:00 AM

0192_ALTA_Instructions_V3.indd 16-17 10/21/15 11:00 AM