US Digital E4P User manual

E4P Assembly Instructions
[email protected] ▪ www.usdigital.com
Local: 360. 60. 468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: [phone]
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
E4P Assembly Instructions
v1.0
Page 1
Step 1:
Place base over shaft. Secure base to mounting surface
using two screws. (Centering tool optional)
Transfer Adhesive: Peel off paper backing, place
centering tool into center hole of base, slip centering tool
onto shaft and slide base and centering tool down onto
mounting surface as one piece. Press to form a good
bond, then slip centering tool off shaft and continue with
standard mounting instructions.
Step 2:
Place codewheel onto shaft with pattern-side down
towards base.
Step 3:
Position spacer/installation tool onto codewheel.
Spacer/installation tool provides a nominal air gap of
0.08”. Press down firmly until tool bottoms out on base
latches.

E4P Assembly Instructions
[email protected] ▪ www.usdigital.com
Local: 360. 60. 468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: [phone]
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
E4P Assembly Instructions
v1.0
Page
Step 4:
Snap cover down onto base. With thumb and finger,
squeeze base latches together to ensure they are fully
engaged with the cover.
Step 5:
Attach cable.