US Digital E6 User manual

E6 Differential Assembly Instructions
[email protected] ▪ www.usdigital.com
Local: 360. 60. 468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: [phone]
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
.0
Page 1
Please Note:
These instructions apply to the E6 differential version only.
Step 1:
Place encoder base onto mounting surface. Slip
centering tool over the shaft and into the center
hole of base. While holding pressure on the
centering tool, tighten mounting screws. Remove
centering tool.
Step 2:
Place spacer tool around shaft. Slip hubdisk
assembly onto shaft with codewheel disk towards
top until it bottoms out against spacer tool.
Step 3:
Tighten set screw with provided hex wrench while
pressing down on hub. Remove spacer tool.
Hub Set Screw:
– 3 in-lbs torque

E6 Differential Assembly Instructions
[email protected] ▪ www.usdigital.com
Local: 360. 60. 468 ▪ Sales: 800.736.0194
Support: 360.397.9999 ▪ Fax: [phone]
1400 NE 136
th
Ave. ▪ Vancouver, Washington ▪ 98684 ▪ USA
.0
Page
Step 4:
Press line driver onto module pins until it reaches
the end of its motion.
Caution!
To avoid injury make sure that the line driver is
held properly (as sho n) during installation,
module pins are sharp!
Step 5:
Orient module with connector pins toward the top.
Gently slide module onto base. Fit module onto
the two alignment pins on base and secure with
two 4-40 x 1/ ” pan head screws (supplied).
Step 6:
Place cover over assembly and secure with two 4-40
x 5/8" flat head screws (supplied).
Module Screws
3.5 – 4 in-lbs torque
Cover Screws
–
4
i
n
-
lbs torque