V-tech VM312 User manual

Installation guide
VM312
VM312-2
VM302
Go to www.vtechphones.com
to register your product for
enhanced warranty support
and latest VTech product news.
Mount the baby monitor
Use a pencil to mark two
holes in parallel. Make sure
they are the same distance
apart as the wall mount at
the bottom of the baby unit.
Drill two holes in the wall
(7/32” drill bit). If you drill
the holes into a stud, insert
the screws into the holes.
Tighten the screws until
only 1/4 inch of the screws
are exposed.
Align the holes on the wall
mount with the screws on
the wall.
Slide the wall mount down
until it locks into place.
Pan or tilt to adjust the baby
unit angle.
Check for reception strength
and camera angle before drilling
the holes.
Specifications are subject to change without notice.
© 2014 VTech Communications, Inc.
All rights reserved. 05/14. VM312-X_IG_V1.0
Document order number: 96-009889-010-100

Parts checklist
Required parts and tool
x 2
x 2 Parts and tool are not included,
and are required to purchase
separately.
x 1
1 set for VM302/VM312
2 sets for VM312-2
Place the baby monitor
Place the parent unit within the operating range of the baby unit.
We recommend the parent unit is at least 3 feet away from the
baby unit to avoid audio feedback. If you still experience audio
feedback, move the parent unit and the baby unit farther apart.
For better image quality, do not place the baby unit too far away from your baby.
1 set for VM312/VM312-2