V-tech Switch&Go Dinos Eggs Triceratops User manual

Instruction Manual
EGGS
Triceratops

3
INTRODUCTION
Assemble this tough Triceratops, then switch it into a powerful car
and back again in just a few simple steps! Let’s switch and stomp!
Off / Dino Mode /
Vehicle Mode Switch Talk Button

4
INCLUDED IN THE PACKAGE
• Switch & Go Dinos®Eggs Triceratops
• 15 Pieces for Assembly
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part of
this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
GETTING STARTED
Exit Try-Me Mode:
The product is in try-me mode in the packaging. To exit try-me
mode, just slide the Off/Dino Mode/Vehicle Mode Switch from
Vehicle mode to Dino mode/Off.
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit. Use a screwdriver
to loosen the screw, and then open the
battery cover.
3. Remove the old battery by pulling up on
one end of the battery.
4. Install 1 new AAA battery following the
diagram inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the
screw to secure.

5
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its materials
can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with your local council for kerbside collections.

7
ASSEMBLY INSTRUCTIONS
1. Identify the following pieces for assembly:
01 02
03
04 05 06 07
08 09 10 11
12 13 14 15

8
2. Separately install the A, B, C, D, E, F and G parts as shown in the
illustrations.
A
B
C
01
08
09
03
04
14
02
B

9
D
A
D
E
06
10
12
13
11
07

10
F
G
15
05
E
C