V-tech TOOT-TOOT Cory Carson The Carson Playhouse Assembly Instructions

Parent’s Guide
91-003946-000 UK
The Carson Playhouse

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01
C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

2
2
INTRODUCTION
Thank you for purchasing the VTech®Toot-Toot Cory Carson®The
Carson Playhouse!
Get ready to play with Cory and Chrissy in their playhouse. Place the
mini characters on the PlayZone location to hear fun phrases and
sounds. Then, press the mailbox to launch the character.
Tyre Swing
On/Off
Switch
Seesaw
Mailbox
Launcher
Halle Helicopter
PlayZone Location
Mini Cory Mini Chrissy

3
3
INCLUDED IN THIS PACKAGE
One mini Chrissy
One house One base
One tyre swing
One mini Cory
One seesaw
One ramp track
One seesaw base One tree
One tree base
One Halle piece
- One label sheet
- One Parent’s Guide

4
4
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE: Please keep this Parent’s Guide as it contains important
information.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
bottom of the Base. Then, use a
screwdriver to loosen the screw
and remove the cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
• UsenewalkalinebatteriesorfullychargedNI-MH(NickelMetal-
hydride) rechargeable batteries for best performance.
• Useonlybatteriesofthesameorequivalenttypeas
recommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard
(carbon-zinc), rechargeable or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity(+and-).

5
5
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Removerechargeablebatteriesfromthetoybeforecharging(if
removable).
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
WARNING:
Adultassemblyrequiredforbatteryinstallation.
Keep batteries out of reach of children.

6
6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in Battery Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

7
7
LABEL APPLICATION
Please securely stick the labels to the play set as
indicatedbelow:
13
6
10
10 11
12
13
9
7
4
11
8
12
5
3
2
2
3
7
6
5
8
9
4
11

8
8
ASSEMBLY INSTRUCTIONS
With The Carson Playhouse, safety comes first. Adult assembly
isrequired.Foryourchild’ssafety,donotletthemplaywiththis
toy until it is fully assembled.
1. Place the Base on a flat surface and insert the House into the
Base. Press down firmly, the house will click into place. Then
insert the Halle Piece into the House.
2. Connect the Tyre Swing to the Tree and then insert the Tree
into the Tree Base.
3. Connect the Seesaw to the Seesaw Base.

9
9
Theplaysetmaybeconfiguredinavarietyofways:
4. Connect the Tree and the House with the Ramp Track, as
shown on the left.You can also connect the Tree to the House
as shown on the right.
Once you’ve completed the above steps, you are ready to play! Mini
characters from other sets (each sold separately) are also compatible.
PRODUCT FEATURES
1. On/Off Switch
To turn the unit On, slide the On/
Off Switch to the On position. To
turn the unit Off, slide the On/Off
Switch to the Off position.