…Safety precautions
9
䡲Never fill the rinse agent reservoir or the regeneration salt reservoir with detergent.
If this were to happen, however, do not operate the appliance under any circum-
stances, as this could cause expensive damage to it. Please contact our service
centre, which can be found in the 'Repair service' section.
䡲After filling the salt reservoir, run the «Pre-rinsing» programme.
䡲Do not wash objects that are soiled with inflammable or corrosive solvent, paint,
wax, chemicals (acids or bases) or iron chippings or that can shed fibres in the
appliance.
䡲Do not use solvents (e.g. turpentine, benzine) instead of, or in addition to, water
in the appliance – fire or explosion hazard!
䡲Before closing the appliance door and starting a programme ensure that there are
no foreign objects or pets in the appliance. Foreign objects which can rust, such
as nails and paper clips, can damage parts of the appliance as well as the dishes.
䡲Avoid opening the appliance door during operation. The dishes and water may
be hot – scalding hazard! The steam that escapes can damage wood combina-
tion fascias. Spectacles can steam up, impairing your vision.
䡲Do not leave the premises for a longer period of time when the appliance is in
operation.
䡲During longer absences, always turn off the water tap before cutting the power
going to the appliance by pulling out the plug or switching off the fuse. Never pull
the plug out of the mains socket by the cable. The mains socket and the water con-
nection are generally located in the cabinet adjacent to the appliance (under the
kitchen sink, behind the waste bin).
䡲Do not spray the outside of the appliance with water. Do not use a steam cleaner.
䡲From time to time, check the drain hose for tears, kinks, twists, bends, etc.
