V-ZUG 705 User manual

Installation instructions
Oven
Type of construction 60-381
J705.113-0
6.3.08 ITH
1
These installation instructions apply to the model: 705
Identification plate
AOpen the appliance door. The identification plate is located on the left-side panel.
AInformation on the necessary mains voltage, type of current and fuse protection is to be obtained from the identification plate.
1. Place appliance in front of the niche and insert the mains plug.
2. Carefully slide the appliance into the niche until it is flush with the front of the cabinets, ensuring that the mains cable is not
pinched.
3. Open the appliance door and secure the the appliance at the sides with the 4 enclosed screws A.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strict-
ly observed.
Electrical connections
Electrical connections must be carried out by trained electricians in accordance with the guidelines and standards for low volt-
age installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are per-
missible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should al-
ways be checked.
Installation
It is not possible to install the appliance above an extractor oven because of the extraction pipes that lead upwards.
293
~52
45
AA
20
600
min. 550
20
min. 550
min. 50
600
381
Niche
378
Appliance
min. 550
Niche
567
Appliance
Electrical
connection box
Identification plate
596
Appliance
560–568
Niche
560–568
Niche
Installation variant

Installation instructions
Oven
Type of construction 60-381
J705.113-0
6.3.08 ITH
2
Installing with a second oven in the same niche
Below the second oven
Above the second oven
If a second oven is installed in the same niche (above or below the appliance), you should use bracket set 60 to support the
upper appliance.
50
600380
980
min. 550
420
ø 100
600380
980
598
Appliance
560–568
Niche
378
Appliance
567
Appliance
Bracket set 60
567
Appliance
Oven
600 380
980
min. 550
380600
980
50
598
Appliance
378
Appliance
567
Appliance
560–568
Niche
Bracket set 60
567
Appliance
Oven