Valcom VE5090AL User manual

Issue 3
1 947774
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
VE5090AL
IP PoE One-Way/Talkback Surface Mount
FlexHorn With Long Line Extender
INTRODUCTION
The VE5090AL IP One-Way/Talkback Surface
Mount FlexHorn unit enables loudspeaker voice
paging anywhere on an Ethernet network. The
VE5090AL consists of a high efficiency Class-D
Horn and a Network interface, allowing stand
alone capability when used with a SIP telephone
system or can be accessed from a variety of
Valcom managed VoIP products. Power is
provided to the VE5090AL via a Power over
Ethernet (PoE) switch meeting the 802.3af
specification.
SPECIFICATIONS
Access Methods
SIP telephone system
PBX, FXO Port w/VE801x
POTS telephone set w/VE801x
PBX, FXS Port w/VE802x
Valcom M Cast Page Group
Features
RJ-45 for network connection
Network activity LEDs
Power over Ethernet (PoE) 802.3af
compatible
Painted stainless steel backbox
Brushed stainless steel grille
Dimensions/Weight
Horn Enclosure
10.0”H x 12.2" W x 4.0" D
(25.4cm H x 30.9cm W x 10.2cm D)
Weight: 7.4 lbs. (3.4 kg)
Network Interface
6.1” H x4.4" W x 2.0" D
(15.5cm H x 11.2cm W x 5.1cm D)
Weight: 0.60 lbs. (0.3 kg)
Nominal Power Requirements
Via 802.3af (PoE) Ethernet Switch: Class 3
Environment
Network Interface
Temperature: 0 to +40° C
Humidity: 0 to 85% non-precipitating
PSE: (Power Sourcing Equipment) to be
compliant to IEEE 802.3af
Suitable for indoor installation
Horn Enclosure
Suitable for indoor or outdoor installation
Precautionary Designations

2 947774
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference when the equipment is operated
in a commercial environment. This
equipment generates, uses and can radiate
radio frequency energy and if not installed
and used in accordance with the instruction
manual, may cause harmful interference to
radio communications. Operation of this
equipment in a residential area may cause
harmful interference in which case the user
will be required to correct the interference at
his own expense.
INSTALLATION
Operation
The VE5090AL provides IP loudspeaker paging
access via network connection to customer
telephone system or stand alone telephone set.
Interface to customer telephone system can be
via SIP registration, FXO or FXS port (with
appropriate PBX connection and Valcom
VIP-801x/802x) or Valcom servers.
Network Interface Mounting
The VE5090AL Network Interface is designed for
wall or table/shelf mounting and must be within
100 meters of the network switch.
Table/Shelf: Provided with the VE5090AL
Network Interface are four rubber stick on pads.
Peel pads off their carrier backing and place at
the four corners of the bottom of the unit.
Wall: Using the wood screws provided, secure
the VE5090AL Network Interface to the wall.
Speaker Mounting
Remove the wall speaker enclosure from the
packing container. Using a Phillips screwdriver,
remove the two screws securing the grille to the
enclosure. Remove the grille and remove any
hardware packed inside the enclosure.
Pre-drilled 13/64” mounting holes in the back of
the enclosure are designed to fit a single gang,
double gang or octagon outlet box. If not
attaching to an outlet box, use the enclosure as a
template. Hold the enclosure in the desired
position on the wall and mark the location of
mounting holes. Depending on wall construction
type, prepare the mounting hole locations on the
wall to securely attach the enclosure.
Wiring may be inserted through the large hole in
the back of the enclosure, or through the
knockout hole in the top of the enclosure. Use
mounting hardware (not included) appropriate for
the wall type to securely mount the enclosure to
the wall. (See Figure 2)
After making required signal connections, align
the grille/speaker assembly with the enclosure.
Install the four supplied tamper-resistant screws
through the grille into the enclosure. Use the
supplied security hex bit to tighten the screws
securely.
IMPORTANT SAFETY INFORMATION
CONSIGNES DE SÉCURITÉ IMPORTANTES
1. Read these instructions.
Lisez ces instructions.
2. Keep these instructions.
Conservez ces instructions.
3. Heed all warnings.
Respectez tous les avertissements.
4. Follow all instructions.
Suivez toutes les instructions.
5. Do not use this apparatus near water.
Ne pas utiliser cet appareil près de l'eau.
6. Clean only with dry cloth.
Nettoyer avec un chiffon sec.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
Ne pas bloquer les ouvertures de ventilation. Installer formément aux instructions du
fabricant.
8. Do not install near any heat sources such as radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce heat.
Ne pas installer à proximité de sources de chaleur telles que radiateurs, registres de
chaleur, poêles ou autres appareils (y compris les amplificateurs) produisant de la chaleur.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug
has two blades with one wider than the other. A grounding type plug has two blades and a
third grounding prong. The wide blade and thethird prong are provided for your safety. If
the provided plug does not fit into your outlet consult an electrician for replacement of the
obsolete outlet.
Ne pas contourner le dispositif de sécurité de la fiche polarisée ou de mise à la terre. Une
fiche polarisée possède deux lames dont une plus large que l'autre. Une fiche de terre a
deux lames et une troisième broche de mise à la terre. La lame large et la troisième
broche sont fournies pour votre sécurité. Si la fiche fournie ne rentre pas dansvotre prise,
veuillez consulter un électricien pour le remplacement de la prise obsolète.
10.Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles and the point where they exit from the apparatus.
11.Only use attachments/accessories specified by the manufacturer.
N'utilisez que des fixations / accessoires spécifiés par le fabricant.
12. Use only with the cart, stand, tripod, bracket or table specified
by the manufacturer or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
Utilisez uniquement avec le chariot, stand, trépied, support ou table spécifié par le
fabricant ou vendu avec l'appareil. Quand un chariot est utilisé, Soyez prudent lorsque
vous déplacez l'ensemble chariot / appareil pour éviter des blessures dues au
renversement.
13. Unplug this apparatus during lightning storms or when unused for a long period of time.
Débranchez cet appareil pendant les orages ou lorsqu'il n'est pas utilisé pendant une
longue période de temps.
14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way. Such as when the power supply cord or plug is
damaged, liquid has been spilled, objects have fallen into the apparatus or the
apparatus has been exposed to rain or moisture and does not operate normally or has
been dropped.
Confiez toute réparation à un personnel qualifié. Une réparation est nécessaire lorsque
l'appareil a été endommagé de quelque façon. Par exemple lorsque le cordon
d'alimentation ou la fiche est endommagé, du liquide a été renversé, si des objets sont
tombés dans l'appareil ou le appareil a été exposé à la pluie ou à l'humidité et ne
fonctionne pas normalement ou s'il est tombé.

3 947774
Power Connections
The only method of powering a VE5090AL
Network Interface is via a Power over Ethernet
(PoE) switch or power injector meeting the
802.3af specification.
Make all required signal connections before
connecting to Ethernet switch or power injector
meeting the 802.3af specification.
Network Connection
The VE5090AL Network Interface has one RJ-45
network connector Network Interface Use a
standard Ethernet patch cable to connect the
NETWORK connector of the VE5090AL Network
Interface to a PoE Ethernet switch.
Signal Connections
The VE5090AL Network Interface has one RJ-45
Signal connector. Connect a standard EIA/TIA
568B patch cable to the RJ-45 Signal connector.
Connect the white/brown pair of the patch cable
to the audio leads from the horn. A VM-186
Junction Box is provided for convenient access to
the wire pairs. (See Figure 1).
If a call-in switch for Talkback purposes is
desired, connect the normally open call switch to
the white/blue pair of the patch cable or VM-186.
Status Indicator Lights
The VE5090AL has 2 status indication lights
located on network jack:
Green LED: (Link) Indicates Ethernet
connection when illuminated.
Yellow LED: (Activity) Indicator flashes to
indicate network activity.
Setup
Information specific to your application will need
to be programmed into the VE5090AL using a
computer. The PC used for programming should
be connected to the same subnet as the
VE5090AL.
Setup will be done using the IP Solutions Setup
Tool. The IP Solutions Setup Tool may be
downloaded from the Valcom web site at
http://www.valcom.com/vipsetuptool.
TECHNICAL ASSISTANCE
Assistance in troubleshooting is available from
the factory. Call [phone] and ask for
Valcom Engineered Solutions Technical Support
or visit our website at www.ValcomES.com.
When requesting assistance, you should include
all available information. It is strongly suggested
that you go to the web site and follow the trouble
resolution procedure at http://www.valcom.com.
Valcom equipment is not field repairable.
Valcom, Inc. maintains service facilities in
Roanoke, VA. Should repairs be necessary,
attach a tag to the unit clearly stating your
company name, address, phone number, contact
person and the nature of the problem. Send the
unit to: Valcom, Inc.
Repair & Return Dept.
5614 Hollins Road
Roanoke, Va. 24019-5056
Information provided is subject to change
VALCOM LIMITED WARRANTY
Valcom, Inc. warrants its products only to the original purchaser, for its own use, to be free from defects in materials and workmanship under conditions of normal
use and service for a period of one year from the date of shipment. This Limited Warranty obligation shall be limited to the replacement, repair or refund of any
such defective device within the warranty period, provided that:
1. inspection by Valcom, Inc. indicates the validity of the claim;
2. the defect is not the result of damage, misuse or negligence after the original shipment;
3. the product has not been altered in any way or repaired by others and that factory sealed units are unopened (a service charge plus parts
and labor will be applied to units defaced or physically damaged);
4. freight charges for the return of products to Valcom are prepaid;
5. all units 'out of warranty' are subject to a service charge. The service charge will cover minor repairs (major repairs will be subject to
additional charges for parts and labor).
This Limited Warranty is in lieu of and excludes all other warranties, expressed or implied and in no event shall Valcom, Inc. be liable for any
anticipated profits, consequential damages, loss of time or other losses incurred by the buyer in connection with the purchase, operation,
maintenance, installation, removal or use of the product. The maximum liability of Valcom under this warranty is limited to the purchase price of the
specific Product covered by the warranty.
Disclaimer. Except for the Limited Warranty provided herein, the product is provided “as-is” without any warranty of any kind whatsoever including, without
limitation, any WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT.
This warranty specifically excludes damage incurred in shipment. In the event a product is received in damaged condition, the carrier should be notified
immediately. Claims for such damage should be filed with the carrier involved in accordance with the F.O.B. point.
Headquarters:
Valcom, Inc.
5614 Hollins Road Roanoke, VA 24019-5056
Phone: [phone] FAX: [phone]

4 947774
ALCOMVNETWORK
NORMAL OPEN
CALL IN SWITCH
MOMENTARY CLOSED
(OPTIONAL)
CONNECTION
RJ45 NETWORK
FRONT SIDE
STANDARD
RJ45 PATCH CABLE
PAGING HORN
VM-186
RJ45
WHITE/GREEN
GREEN
WHITE/BROWN
BROWN
BROWN
BLUE
WHITE/BLUE
BLUE
WHITE/ORANGE
ORANGE
WHITE/GREEN
GREEN
WHITE/BROWN
BROWN
WHITE/BLUE
BLUE
WHITE/ORANGE
ORANGE
INTERFACE
VALCOM
(T568B)
Figure 1. Signal Connections
Figure 2. Speaker Mounting (Flexhorn supplied attached to grille)