Valcom PagePac V-5331001 User manual

Issue 2
1947175
1 WATT VOICE-COIL HORN
V-5331001
by
PagePac®
INTRODUCTION
The 1 Watt Voice-Coil Horn is suitable for paging
in smaller, quiet warehouse and manufacturing
facilities. Normal mounting height for a horn is 15
to 20 feet. However, in a system with talk-back
(hands-free answer back) the speaker may have
to be mounted as low as 8 to 12 feet and set at a
lower power setting. Talkback is not recom-
mended for noisy environments.
SPECIFICATIONS
FEATURES
• Design enables the adjustment of sound level
via speaker transformer taps. As the taps are
turned down, the power consumption from the
amp also goes down and does not consume the
full one watt.
•The 1 Watt Voice-Coil Horn is not compatible
with 25 or 70V systems
Nominal Specifications
• Frequency Response: 700Hz - 6kHz
• Dispersion: 80°
• Output: 107 dB SPL @ 1W, 1 Meter
Power Requirements
• .016 to 1 Watt adjustable
Dimensions/Weight
• 3 lbs.(1.4 kg)
6.8”Dia. x 8.2"D (17.3cm x 20.8cm)
Environment
• Temperature: 0 to 40°C (32 to 104°F)
• Humidity: 0 to 85%
INSTALLATION
Do not connect more than two horns per talkback
zone. Speakers must be mounted in locations
that provide a clear sound path to the area being
paged. Avoid placing speakers in front of shelves,
partitions, or other obstructions. To avoid feed-
back, do not place telephones close to horns.
Various power outputs/tap settings can be easily
selected on the speakers, using the rotary power
switch.
MOUNTING
Loosen the wing nut and remove the tapered lock-
ing pin. Separate the horn from the bracket.
Mount the bracket using appropriate hardware
(not supplied). Position the horn back on the
bracket for optimum sound direction and install
locking pin and wing nut. (see Figure 1).
WIRE CONNECTIONS
A clear plastic cover protects the horn screw ter-
minals and provides strain relief for the wires.
1. Remove the two screws from the plastic cover.
2. Connect the audio wires to the horn.
3. Connect the (+) side of the speaker wire to ter-
minal 2. Connect the (-) common side of the
speaker wire to terminal 1 (see Figure 2).
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
firealarmresources.com

2947175
4. Do not replace the plastic cover until final
power adjustments have been made.
FINAL POWER ADJUSTMENTS
Ensure that the speaker is set to its lowest setting
(this will prevent an excessively loud page when
first used). While a page is in process, adjust the
volume control with a screwdriver. Turn clockwise
to increase the volume (see Table 1).
TECHNICAL ASSISTANCE
When calling, have a VOM and a telephone test
set available and call from the job site. Call (540)
427-3900 and ask for PagePac Technical Sup-
port, or call [phone] for Valcom 24-hour
Automated Support or visit our websites at
http://www.pagepac.com and www.valcom.com.
Should repairs be necessary, attach a tag to the
unit clearly stating company name, address,
phone number, contact person, and the nature of
the problem. Send the unit to:
PagePac®Repair Dept.
Valcom, Inc.
5614 Hollins Road
Roanoke, VA 24019-5056
FIGURE 1
FIGURE 2
MOUNTING ON FLAT SURFACE
WING NUT
MOUNTING BRACKET
ANDING
OT
ED)
TAPERED
LOCKING
PIN
SPEAKER CABLE
VOLUME LEVEL
CONTROL
(USE ONLY SETTINGS
1 TO 4)
TERMINALS
Table 1: SWITCH SETTINGS
SWITCH
SETTINGS IMPEDANCE
OHMS
3.4 Vrms Input
POWER SPL
WATTS DECIBELS
1 720 0.016 89
2 180 0.063 95
3450.25101
4 11.5 1.0 107
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
firealarmresources.com

3947175
NOISE
LEVEL
IN dB
68 dB
69 dB
70 dB
71 dB
72 dB
73 dB
74 dB
75 dB
76 dB
77 dB
78 dB
79 dB
80 dB
81 dB
82 dB
83 dB
84 dB
85 dB
86 dB
87 dB
88 dB
89 dB
90 dB
91 dB
45
40
35
30
25
22
80
70
65
60
55
50
45
40
35
30
25
22
100
90
80
70
65
60
55
50
45
40
35
30
25
22
20
100
90
80
70
65
60
55
50
45
40
35
30
25
22
20
SPL-89
.016 WATT SPL-95
.063 WATT SPL-101 .25 WATT SPL-107 1.0 WATT
1 WATT (VOICE-COIL) HORN PROJECTION DISTANCE
SOUND PRESSURE LEVELS AND WATTAGE SETTINGS FOR 3.4 VOLT SPK
WIRE EACH SPEAKER ON ITS OWN MINIMUM 22 GA. WIRE RUN.
WIRE RUN NOT TO EXCEED 300 FEET.
120'
60'
45'
Below 70 dB
90 to 91 dB
70 to 88 dB
WIDTH
BACKWASH
10' TO 20' Side to Side
Figure 3
Technical Manuals Online! - http://www.tech-man.comTechnical Manuals Online! - http://www.tech-man.com
firealarmresources.com