UP-V5500 Page 4 of 74
3. Installation method
¾MCR Configuration
1. Overview
2. Setup
3. Start MCR Configuration
4. MCR Configuration Tool
5. MCR information display
6. Detail control
7. Tool Bar
¾THE METHOD TO CHANGE LANGUAGE(Microsoft POSReady)
¾POS TERMINALDRIVERAND UTILITYOVERVIEW
¾TOUCH SCREEN SET-UP
¾PCB OVERVIEW
1. System Main B/D
1-1. System Block Diagram
1-2. Main B/D Block Diagram
1-3. Components Layout
1-4. Connector Pin Assignment
2. LCD unit Sub-Control B/D
2-1. Block Diagram
2-2. General Specification
2-3. Components Layout
2-4. Connector Pin Assignment
3. Magnetic Card ReaderInterface B/D
3-1. Block Diagram
3-2. General Specification
3-3. Components Layout
3-4. Connector Pin & Software Interface Description
4. LED B/D
4-1. Block Diagram
4-2. General Specification
4-3. Components Layout
4-4. Connector Pin Assignment
¾CABLE PINASSIGNMENT
¾EXPLODED DRAWING
yDue to continuous enhancements of the system features and the wide range of products available, the contents of this manual are subject to change without notice.
yThe company is not responsible for any damage caused by using products other than in their standard specification, or by not conforming to the instructions and
warnings set forth in this and any other manual.
