Vanco 280902 User manual

PRODUCT MANUAL
HDMI® 1x2 Splitter
Part Number: 280902

1
Ⅰ.INTRODUCTION
Part Number 280902, HDMI 1x2 splitter distributes 1 HDMI source to 2 HDMI
displays simultaneously. It supports High Definition Resolution 1080p, 3D,
digital audio format, and DTS/Dolby Digital.
Ⅱ. SPECIFICATIONS:
Input Video Signal
0.5 -1.0 volts p-p
Input DDC Signal
5 volts p-p (TTL)
Max Single Link Range
1920X1080, 1080P
Output Video
HDMI 1.3 + HDCP1.0/1.1/1.2
Resolutions DTV/HDTV
480p/576i/576p/720p/1080i/1080P
HDMI Version
HDMI 1.3
Operating Frequency
Up to 225MHz
EIDI Duration
4 seconds
Power supply
DC 5V

2
Ⅲ.CONNECTION
a) Connect the input source and output displays to the HDMI Splitter.
*Please refer to the Connection Image.
b) Connect the DC 5V power supply to the splitter. Please note that power
supply with higher voltage may damage the splitter.
c) When input source and output displays are connected and turned on, the
corresponding LED will light.
Attention: In order to protect the splitter and your devices, please make sure the
splitter is
powered off before you attach in or extract video source and displays. Please
insert and
extract HDMI cables gently.
Ⅳ.INTERFACE

3
①Power LED ②Power Supply Socket
③HDMI Input ④LED of HDMI Input
⑤HDMI1 Output ⑥LED of HDMI1 Output
⑦LED of HDMI2 Output ⑧HDMI2 Output
Ⅴ.BOX CONTENTS:
Item
Qty
Remark
HDMI splitter 1 × 2
1 PCS
Power
1 PCS
DC5V/1A
User Manual
1 PCS
en

4
Ⅵ.FAQ
A) . The splitter doesn’t appear to be functioning.
First, check the LED lights and see if the power supply is in good condition and well
connected. Make sure all cables are in good condition and well connected. Make sure
the length of the cables is within the maximum supported length of this splitter. Try to
connect the input source to the display directly to see if it displays normally.
B) If the maximum resolution the two displays supported is not the same, what
resolution be displayed?
The splitter will display at the lower resolution to both displays.
Ⅶ.CONNECTION