Vanco 280547 User manual

VGA over Cat5e/
Cat6 Extenders
with Audio
Vanco Part Number:
280547 (Distribution
System)
280548 (Additional
Receiver)
Technical Support
www.vanco1.com • [email protected] • 800-626-6445
HOME
THEATER

www.vanco1.com 800-626-6445 2
DEAR CUSTOMER
Thank you for purchasing this product.
For optimum performance and safety, please
read these instructions carefully before
connecting, operating or adjusting this product.
Please keep this manual for future reference.
The Vanco 4 Zone VGA + Audio over Cat5e/Cat6 Distribution System (280547) allows VGA and
audio signals to be transmitted from a distribution hub to up to 4 receivers over single Cat5e or
Cat6 cables at a transmission range of up to 1000 ft. The 280547 includes a distribution hub
and one receiver, additional VGA + Audio over Cat5e/Cat6 receivers can be purchased separately
(Vanco part # 280548). For control and ne tuning, the 280547 offers EQ and GAIN controls
on the receiver balun to fully adjust for distance range and transmission signal optimization. The
280547 also features dual output, which allows for one display with audio at origin location and
up to 4 additional display devices with audio in a remote location. The 280547 and 280548
supports computer resolutions UXGA (1600x1200), SXGA (1280x1024), XGA (1024x768),
SVGA (800x600) and VGA (640x480).

www.vanco1.com 800-626-6445 3
FEATURES
4 Zone VGA+Audio over Cat5e/Cat6 Distribution System
Part # 280547
• Allows VGA and Audio Signals to be Transmitted
from the Distribution Hub to up to 4 receivers
over single Cat5e or Cat6 cables
• Transmission Range up to 1000 ft.
• 350 MHz signal transmission bandwidth
• Includes distribution hub and one receiver
• Additional VGA + Audio over Cat5e Receivers
can be purchased separately - Vanco Part
Number 280548
• Output allows for one display with audio at
origin location and up to 4 additional display
device with audio in a remote location
• Receiver features Dual VGA outputs and a
single Cat5e/Cat6 output for cascading to up to
3 additional units
• Receiver features adjustable EQ and GAIN
controls
• Supports computer resolutions UXGA
(1600x1200) SXGA (1280x1024), XGA
(1024x768), SVGA (800x600) and VGA
(640x480)
• Supports up to 100 meters (330 ft) with
resolution 1200x1600
• Supports up to 120 meters (396 ft) with
resolution 1280x1024
• Supports up to 180 meters (594 ft) with
resolution 1024x768
• Supports up to 200 meters (660 ft) with
resolution 800x600
• Supports up to 300 meters (1000 ft) with
resolution 640x480
• Power Supply: (2) 12V DC, UL Listed
• Distribution Hub Dimensions: 5.31” W x 1.25”H
x 3.13”D
• Receiver Dimensions: 5.31” W x 1.25”H x
3.13”D
VGA+Audio over Cat5/Cat6 Receiver
Part # 280548
• Receiver unit designed to be used with 4 Zone
VGA+Audio over Cat5 Distribution Hub - Vanco
Part Number 280547
• Transmission Range up to 1000 ft.
• 350 MHz signal transmission bandwidth
• Features Dual VGA outputs and single Cat5e/
Cat6 output for cascading to up to 3 additional
units
• Features adjustable EQ and GAIN controls
• Supports computer resolutions UXGA
(1600x1200) SXGA (1280x1024), XGA
(1024x768), SVGA (800x600) and VGA
(640x480)
• Supports up to 100 meters (330 ft) with
resolution 1200x1600
• Supports up to 120 meters (396 ft) with
resolution 1280x1024
• Supports up to 180 meters (594 ft) with
resolution 1024x768
• Supports up to 200 meters (660 ft) with
resolution 800x600
• Supports up to 300 meters (1000 ft) with
resolution 640x480
• Power Supply: 12V DC, UL Listed
• Dimensions: 5.31” W x 1.25”H x 3.13”D

www.vanco1.com 800-626-6445 4
PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make sure the following items are
contained in the shipping carton:
280547:
• Distribution Hub and (1) Receiver
• (2) 12V/2A DC Power Supplies
• User’s Manual
280548:
• (1) Receiver
• (1) 12V/2A DC Power Supply
• User’s Manual
CONNECT AND OPERATE
1. Connect 1 source such as a PC or laptop that has a VGA output to the VGA input on the distribution hub
(a VGA output can also be connected at the distribution hub).
2. Connect the audio source using a 3.5mm cable into the 3.5mm jack (input) on the distribution hub (there
is also an audio ouput on the distribution hub).
3. Connect 1 display such as an HDTV or HD Projector that has a VGA input to the VGA output on the
receiver balun (280547/280548 supports dual output and can output video at both distribution hub and
receiver baluns).
4. Connect the audio output on the receiver balun to the display device using a 3.5mm cable
(280547/280548 supports dual output and can output audio at both distribution hub and receiver
baluns).
5. Connect a single Category 5e or 6 cable to both distribution hub and receiver baluns.
6. For power, plug in the source rst, followed by the Receiver(s) and then Distribution hub (two 12V DC
power supplies included for 280547, one 12V DC power supply included for 280548), followed by the
output connected.
7. Power on each device in the same sequence (receiver and distribution hub will already be powered when
plugged in).
At this point the display connected should display the source signal connected to the distribution system. If
no signal is being displayed, connect a shorter Cat5e/6 cable (less than 15 ft). If no signal is still displaying,
adjust the EQ and GAIN controls, if a signal displays with the shorter category cable, the EQ distance will
need to be adjusted to the longer category cable being used. If a display is having difculty receiving a signal,
access the display’s menu and adjust the resolution (lowest to highest until signal is displayed). A 24 Hz
vertical refresh rate may work better than 60 Hz or higher.

www.vanco1.com 800-626-6445 5
CONNECTION DIAGRAM

www.vanco1.com 800-626-6445 6
LIABILITY STATEMENT
Every effort has been made to ensure that this product is free of defects. The manufacturer of this product
cannot be held liable for the use of this hardware or any direct or indirect consequential damages arising
from its use. It is the responsibility of the user and installer of the hardware to check that it is suitable for
their requirements and that it is installed correctly. All rights are reserved. No parts of this manual may be
reproduced or transmitted by any form or means electronic or mechanical, including photocopying, recording
or by any information storage or retrieval system without the written consent of the publisher.
Manufacturer reserves the right to revise any of its hardware and software following its policy to modify and/or
improve its products where necessary or desirable. This statement does not affect the legal rights of the user
in any way.
TECHNICAL SUPPORT
In case of problems, please contact Vanco Technical Support by e-mail at [email protected] or call 1-800-
626-6445 between the hours of 8am and 5pm central US time zone on Monday through Friday.
When calling, please have the Model Number, Serial Number (afxed to the bottom of the unit) and Invoice
available for reference during the call.
Please read this Instruction Manual prior to calling or installing this unit, since it will familiarize you with the
capabilities of this product and its proper installation.
All active electronic products are 100% inspected and tested to insure highest product quality and trouble-
free installation and operation. The testing process utilizes the types of high-denition sources and displays
typically installed for entertainment and home theater applications.
For additional information please visit www.vanco1.com

www.vanco1.com 800-626-6445 7
LIMITED WARRANTY
With the exceptions noted in the next paragraph, Vanco warrants to the original purchaser that the equipment
it manufactures or sells will be free from defects in materials and workmanship for a period of one year from
the date of purchase. Should this product, in Vanco’s opinion, prove defective within this warranty period,
Vanco, at its option, will repair or replace this product without charge. Any defective parts replaced become
the property of Vanco. This warranty does not apply to those products which have been damaged due to
accident, unauthorized alterations, improper repair, modications, inadequate maintenance and care, or use in
any manner for which the product was not originally intended.
Items integrated into Vanco products that are made by other manufacturers, notably computer hard
drives and liquid crystal display panels, are limited to the term of the warranty offered by the respective
manufacturers. Such specic warranties are available upon request to Vanco. A surge protector, power
conditioner unit, or a uninterruptible power supply must be installed in the electrical circuit to protect against
power surges.
If repairs are needed during the warranty period the purchaser will be required to provide a sales receipt
or other acceptable proof of purchase to the seller of this equipment. The seller will then contact Vanco
regarding warranty repair or replacement.

Vanco® International
506 Kingsland Drive
Batavia, Illinois 60510
call: 800.626.6445
fax: [phone]
visit: www.vanco1.com