Vantec CB-ISA225-U3 User manual

Installation Guide
Copyright © 2016 Vantec Thermal Technologies. All Right Reserved. All Registered Trademarks Belong To Their Respective Companies.
Model: CB-ISA225-U3www.vantecusa.com v1.01
Information in this document is subject to change without notice.
Reproduction of these materials in any manner whatsoever without written permission is strictly forbidden.
Printed in China
Printed on Recycled Paper.
When connected properly, the hard drive should be
automatically detected and begin ‘AutoPlay.’
7.
AutoPlay
Disk(D:)
Open folder to view les
Prepare your device and the Adapter.
2.
Verify the package contents.
1. Note that there is an On/Off switch located along the AC power
cable. Please make sure it is Off. (For 2.5” IDE, skip to Step 4c)
3.
Carefully connect the desired hard drive to the adapter.
4a.
2.5”/3.5”/5.25” SATA Device
WARNING: Please make sure the power connectors are oriented
correctly before connecting. Incorrect connection may cause
severe damage to your hard drive and/or electrical shock.
To System USB port
Carefully connect the desired hard drive to the adapter.
4b.
3.5”/5.25” PATA(IDE) Device
*For Jumper settings, please refer to your hard drive manufacturer’s
documentation.
Note:
For ALL IDE device, please set the jumper setting on the drive to Master Single drive mode*.
To System USB port
Proceed to connect the Adapter’s USB to a free USB port.
6.
AutoPlay
Disk(D:)
Open folder to view les
Carefully connect the desired hard drive to the adapter.
Proceed to step 6.
4c.
2.5” PATA(IDE) Device
To System USB port
Note:
Missing pin on the drive
Interface MUST align with the
plugged hole on the adapter
Interface side.
Once securely connected, you may switch ON the Adapter for device that need to
power using AC Adapter. For 2.5” PATA(IDE) device you can skip this step. After
Powering ON, wait 20 seconds before proceeding to the next step.
To System USB port
5.

Federal Communications Commission Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.