Vantec UGT-PCE2S1P User manual

2-Serial/1-Parallel Port PCIe Adapter
User Manual
Model: UGT-PCE2S1P
All brand names and trademarks are properties of their respective owners
All brand names and trademarks are properties of their
www.vantecusa.com
respective owners.

UGT-PCE2S1P Page 2
Contents
Features and Benefits.........................................................3
System Requirements ........................................................4
Package Contents...............................................................4
Hardware Installation ........................................................4
Driver Installation..............................................................5

UGT-PCE2S1P Page 3
Features and Benefits
Features
Compliant with PCI Express Base Specification
1.1
Supports 2 x UART serial port
Built-in 16C450/550 compatible UART
On chip 256 byte FIFOs in transmit and receive
path of each serial port
Serial data transfer rate up to 230400bps
Supports Standard Parallel Port (SPP), Enhanced
Parallel (EPP) & Enhanced Capability Port (ECP)
Parallel data transfer rate up to 1.5Mbps
Bus
PCI-Express x1
Connectors
2 x DB9 male serial connectors
1 x DB25 female parallel connector

UGT-PCE2S1P Page 4
System Requirements
Windows® XP/Vista/7/8 (32/64 bit)
PCI Express-enabled system with an available PCI Express slot
Package Contents
1 x 2-Serial/1-Parallel Port PCIe Adapter
1 x Bracket with two DB9 male serial ports
3 x Low profile brackets
1 x User Manual
1 x Driver CD
Hardware Installation
1. Turn off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the screw and slot bracket from an available PCIe slot.
4. To install the card, carefully align the card’s bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5. Replace the slot bracket’s holding screw to secure the card.

UGT-PCE2S1P Page 5
6. Replace the computer cover and reconnect the power cord.
Driver Installation
1. Insert the provided CD into your CD-ROM drive.
2. At the Windows Desktop, click Start, and then Run.
3. When the prompt displays
For Windows XP/Vista/7/8 32-bit –Enter
“D:\UGT-PC2S1PE\Windows\32Bit\stnsetup.exe”(where “D”
is the designation of your CD drive)
For Windows XP/Vista/7/8 64-bit –Enter
“D:\UGT-PC2S1PE\Windows\64Bit\stnsetup.exe”(where “D”
is the designation of your CD drive)
4. Follow the on-screen instructions to complete the installation.