Vaporesso XROS MINI User manual

USER MANUAL
VAPORESSO XROS MINI

Thank you for choosing Vaporesso
product. Please read this instruction
carefully before use to ensure a perfect
experience. If there is any additional
requirement about this product, please
consult the local agent or contact us
through our website: www.vaporesso.com
EXPLODED VIEW
Dimensions: 98.9 x 23.4 x 13.5mm
POD Capacity: 2ml
POD Resistance: 1.2Ω or 0.8Ω
Battery Capacity: 1000mAh
Charging Current: DC 5V/1A, Type-C
Display: Single 3-Color LED Indicator
SPECIFICATIONS
Drip Tip
Filling Hole
Replaceable POD
LED Indicator
Type-C USB Port

PACKING LIST (1.2ΩVersion)
PACKING LIST (0.8ΩVersion)
1 x VAPORESSO XROS MINI Battery
1 x VAPORESSO XROS Series 1.2Ω POD (2ml)
1 x Type-C USB Cable
1 x User Manual
1 x Warranty Card
1 x VAPORESSO XROS MINI Battery
1 x VAPORESSO XROS Series 0.8Ω MESH POD (2ml)
1 x Type-C USB Cable
1 x User Manual
1 x Warranty Card

Figure 1: Replace the POD

Figure 2: Fill the E-liquid

ENGLISH
USE INSTRUCTIONS
1. Replace the POD
1) Pull out the used POD from the device;
2) Put the new POD into the device rmly.
2. Fill the E-liquid
- Snap off the drip tip from the POD;
- Gently insert the e-liquid lling bottle tip into the lling slot;
- Press down and squeeze the e-liquid through the slot;
- Install the drip tip back and conrm it’s shut rmly;
- Please wait 5 minutes for the e-liquid to soak into the coil completely.
3. Start Vaping
Inhale directly to enjoy extraordinary vaping experience.
4. Battery Level
LED Color Battery Status
High (70%-100%)
Medium (30%-70%)
Low (0%-30%)

PROTECTIONS
5. Charge the Battery
After connecting the Type-C cable to the device, the LED indicator will breathe in red light.
Once the battery is fully charged, the indicator will turn into green light.
Protections Situation Indicator
Low Resistance Protection The device detects an ultra-low resistance. x 5 Stop Output
Short-circuit Protection The device detects a short circuit. x 5 Stop Output
No Load Protection The device does not detect an atomizer. x 5 Stop Output
High Resistance Protection The device detect an ultra-high resistance. x 5 Stop Output
Low Voltage Protection The battery voltage drops too low. x 3 Stop Output
Over Charge Protection The device is fully charged. Stop Charging
Over Discharge Protection The battery voltage drops too low during
vaping.
x 3 Stop Output
Auto-Shut off Protection Constantly vape for 8 seconds or more. x 3 Stop Output

CAUTIONS
1. Please turn off the device when it is not in use.
2. Do not leave the charging device unattended.
3. Do not drop, throw or abuse your device, which may cause damage.
4. Please use a standard USB output charger with proper charging current and voltage range.
5. Keep away from the water or any ammable gas, liquid .
6. Do not expose the device to direct sunlight, dust, moisture or mechanical shock.
7. Do not expose the device to extreme temperature. (Recommended temperature range:
-10~60℃ /14~140 ℉ while using and -10~45℃ /14~113 ℉ while storing).
8. EEE Recycling: the product should not be treated as household waste, instead, it should
be handed over to the applicable collection point for the recycling of electrical and electronic
equipment.
9. Battery Recycling: the product battery should not be treated as household waste, instead, it
should be handed over to the applicable used battery collection point for recycling.
10. Only have your device repaired by Vaporesso. Do not attempt to repair it by yourself as damage
or personal injury may occur.