VARMILO Minilo VXB81 User manual

1
2
·蓝牙设备必须为蓝牙5.0或者以上
·所有与Fn键组合的操作，必须是先按Fn不松手，再按组合的功能键执行功能；按键释放不分先后
注意事项
3 4

3
4
2
1
Caps Lock 指示灯 ： 大写时亮白灯， 小写时灯熄灭。
ESC指示灯 : 充电时指示灯亮起,充满电时熄灭。当电量不足时，ESC指示灯会闪烁。
蓝牙指示灯 ：F 1、 F2、 F3 键指示灯对应通道灯闪烁表示等待配对， 连接成功后熄灭。
·通过Fn+右Alt的按键组合切换查看指示灯和背光灯。
1
2
3
有线/蓝牙模式切换
·通过双模开关来切换模式：有线-蓝牙
·在蓝牙模式下，按Fn + F1、F2、F3切换至1、2、3频道的蓝牙设备进行连接使用

4
3
4
2
1
蓝牙模式连接操作
蓝牙模式重新匹配操作
·双模开关拨到蓝牙模式下，切换成蓝牙模式，然后在需要连接的设备端搜索蓝牙键盘，设备搜索到的
蓝牙键盘名称为“Varmilo V-1/2/3”蓝牙广播时间为5分钟。
·第一次配对需要在键盘上输入密码，并按Enter进行确认。配对成功后，F1键灯常亮，保存蓝牙设备。
·开机后（或者有线转蓝牙后）自动连接最后一次配对中或者连接中的蓝牙设备。蓝牙发射时间为5分钟，
如时间内没有设备连接，则键盘自动进入睡眠状态。
·长按5秒Fn+F1/F2/F3键（分别对应1、2、3频道），断开当前蓝牙设备连接，相应键位灯闪烁，
重新进入配对模式，等待跟新的蓝牙设备进行连接。
键盘关机
·双模开关拨到有线模式下，切换成有线模式，拔掉数据线后键盘关机。

6
5
·有线模式：同步电脑状态睡眠/唤醒。
·蓝牙模式：默认不使用时30分钟后键盘进入睡眠模式，按任意键可唤醒。
·Fn+1，长按3秒，Caps灯指示灯闪三下，设置键盘不使用5分钟后进入省电模式，需按空格键唤醒。
·Fn+2，长按3秒，Caps灯指示灯闪三下，设置键盘不使用30分钟后进入省电模式，需按空格键唤醒。
·Fn+3，长按3秒，Caps灯指示灯闪三下，设置键盘不进入省电模式。
省电模式
·灯效切换：Fn+（-键/=键）, 切换当前灯效下的下一个/上一个灯效模式。
·灯效速度：Fn键+ 方向左/右键，降低/提高当前灯效的动态速度。
·灯效亮度：Fn键+ 方向下/上键，降低/提高当前灯效的灯效亮度。
·背光关闭：Fn+X 键，开启/关闭键盘背光。
·Logo背光灯亮度：Fn键+ Alt + 方向下/上键，降低/提高Logo背光灯的灯效亮度。
灯光效果

7
6
·键值初始化：Fn+D+Backspace，Caps指示灯闪三下，键盘键值出厂设置。
·出厂初始化：Fn+D长按3秒，CapsLock指示灯闪三下，键值灯效恢复出厂设置。
初始化操作
·Fn + Alt + Win键，锁定/解锁Win键
·Fn+左Ctrl， 长按3秒， Caps指示灯闪三下， CapsLock和左Ctrl功能调换。
其他功能
全键与六键无冲切换
·有线模式下，键盘默认全键无冲。有线模式下，组合键Fn+S，长按3秒，Caps指示灯闪三下，
切换为六键无冲。
·蓝牙模式默认6键无冲。

7
7
多媒体功能
Fn + F
Fn + F7 播放/暂停
Fn + H
Fn + F8
Fn + G
Fn + F9 下一曲
按键功能
音乐 计算器 邮件
上一曲
按键功能 按键功能
Fn + J 我的电脑
按键功能
Fn + L
FN+《
FN + “
FN + :
FN+》 End
音量减小
PSC/SRQ PUS/BRKScroll Lock
Home
音量加大 静音
Fn + 11 Fn + 12 Fn + 10
按键组合 按键组合 按键组合 按键组合

8
The new series of Varmilo mechanical keyboards use high quality mechanical switches and Varmilo's own EC switches to guarantee
the stable internal structures and tactility.
To clean a keyboard, pull out the keycaps using a key puller, put the keyboard upside down, pat the back of the keyboard to pourout
impurity, and brush off the impurity and dust that are adhered to the keys. if residuals exist, wipe them ofusing a clean clothwith some
alcohol.After that, dry the keyboard in a cool and ventilated place.To avoid aloose or fallen USB port, do not frequentlyplug.unplug, drag
or bend a keyboard cable, especially for a keyboard with separate cable and keys.
Varmilp comes fromEsperanto Via'‘armilo’ , which means the unique keyboard customized for you.We were born tomeet customer's
personality and variety as well as keep good craftsmanship and stable quality.Varmilo is aiming atbeautifying your desk setup by the
endless improvement and boundless innovation!
By keyboard artist Varmilo

1
2
·The device must be equipped with or connected to Bluetooth 5.0 and above.
·All operations combined with the Fn key must be executed by holding the Fn key down first,
and then press the function key; the order of releasing the keys doesn’t matter.
3 4
Layout
Notes
9

3
4
2
1
Caps Lock indicator light：Lights up for uppercase, lights off for lowercase.
Esc indicator light: Lights up red during charging, lights up green when charging is finished.
Light flashes when the battery is running out.
Bluetooth indicator light: Channel lights of F 1, F2, and F3 flash when waiting for pairing. Lights off
after successful pairing.
· Press Fn+ right Alt to switch between indicator light and backlight.
1
2
3
4
Indicator Light
Mode Switch (Wired/ Bluetooth)
· Switch modes with a two-position switch: Wired - Bluetooth
· In Bluetooth mode, press Fn +F1, F2, F3 to switch to channel 1, 2 and 3 respectively for Bluetooth
device connection.
10

11
3
4
2
1
Bluetooth Connection Instruction
· Switch the two-position switch to Bluetooth mode, and then search for Bluetooth keyboard
(Varmilo VS-1/2/3) in your device. The advertising interval is 5 minutes.
· The first time of pairing requires password. Then press Enter to confirm the connection. After the
successful pairing, F1 will light up and the Bluetooth device will be saved. 3
4
2
1
Bluetooth Re-connection Instruction
· Press and hold down Fn + F1/F2/F3(for Channel 1, 2 and 3 respectively) for 5s to disconnect the
current Bluetooth device. The corresponding indicator light will flash and the keyboard will swap
to the pair mode and could be connected to new devices
Turn off the Keyboard
· Switch the three-position switch to wired mode. Plug out the USB cable and the keyboard will turn
off.

6
12
·Key initialization: Press Fn+D+Backspace, Caps Lock indicator flash three times, and the keyboard
will be reset to original factory setting.
·Factory Reset: Press and hold down Fn + D for 3s, Caps Lock indicator will flash for three times,
and key setting and light effect will be reset to original factory setting.
Initialization Operation
· Adjust light effects: press Fn + - to switch to the previous light effect or Fn + = to the next.
·Adjust light speed: press Fn + ← to slow down the light effect or Fn + → to increase it.
·Adjust brightness: press Fn + ↑ to increase the brightness of the keyboard backlight gradually or
Fn + ↓ to decrease it.
· Turn on/off the light: press Fn + X to turn on/off the backlighting.
·Logo backlight brightness: press FN + Alt + ↑ to increase brightness, FN + Alt + ↓ to decrease.
Lighting effects

7
13
Fn Function
Switch between N-key rollover and 6-key rollover
·In wired mode, the keyboard is N-key rollover at default setting. Press FN+S for 3s until Caps Lock
flashes for 3 times to swap it into 6-key rollover.
·In Bluetooth mode, the keyboard is 6-key rollover at default setting
PUS/BRK
Scroll Lock
Function Function Function
PSC/SRQ
Play/Pause
Next
Previous
Key Combination Key Combination Key Combination
Fn + L
Fn + F7
FN + :
Fn + F9
FN + “
Fn + F8
Mute
Volume-
Volume+Fn + 11 Fn + 12 Fn + 10
Calculator
Email
Music
Fn + F Fn + G Fn + H
End
Home
Computer
Fn+J F n +《 Fn+》

7
14
· Wired mode: Same with computer status--sleep/wake.
· Bluetooth mode/2.4G mode: The keyboard will enter sleep mode in 30 minutes if no key press is
detected. Any press on any key can wake the keyboard.
· Press and hold down Fn + 1 for 3s, Caps Lock indicator will flash for three times.Then the keyboard
will enter power saving mode in 5 minutes if no key press is detected. You can press the space bar
to wake the keyboard.
· Press and hold down Fn + 2 for 3s, Caps Lock indicator will flash for three times. Then the keyboard
will enter power saving mode in 30 minutes if no key press is detected.You can press the space bar
to wake the keyboard.
·Press and hold down Fn + 3 for three seconds, Caps Lock indicator will flash for three times. Then
the keyboard will not enter power saving mode.
Power Saving Mode

7
15
·This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
·Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
·NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Attention
·Fn + Alt + Win: Lock and unlock Win
·Fn + Left Ctrl: Hold down for 3s until Caps Lock indicator will flash for three times to swap the
function of CapsLock and Left Ctrl.
Other Function

16
Attention
·If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to
meet general RF exposure statement.
The device can be used in portable exposure condition without restriction
FCC ID: 2AF8O-VXB81
Warning: Changes or modifications to this unit not expressly approved by the part responsible for
compliance could void the user’s authority to operate the equipment

8

17

9