Vassilias R-331 User manual

INSTRUCTION MANUAL
MODEL: R-331
IMPORTANT
●Ensure the voltage on the rating plate is the same as that in your home.
●The iron should always be turned off before plugging or unplugging from the wall socket.
●Never pull the cord to disconnect from the wall socket; instead, grasp plug and pull to
disconnect.
●Never use the appliance if damaged in anyway.
●When leaving, even when only for a short while, always unplug the iron.
●Burns can occur from touching hot metal parts, hot water or steam.
●Never immerse the iron in water.
●Always place the iron with its back on a firm flat surface when interrupting ironing and
after use.
●The cord should not be allowed to touch the soleplate when it is hot.
●When using the iron for the first time test on an old piece of fabric to ensure the soleplate
and water tank are completely clean.
●This appliance is not intended for use by persons(including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
●Children should be supervised to ensure that they do not play with the appliance.
●The iron must be used and rested on a stable surface.
●When placing the iron on its stand, ensure that the surface on which the stand is placed is
stable.
●The iron is not to be used if it has been dropped, if there are visible signs of damage or if
it is leaking.
●If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.

FILLING WITH WATER
Ensure the iron is disconnected from the power supply.
Turn the steam control knob to position“ ”
Fill with water through water filling inlet.(Do not exceed main level mark on the water
tank.)
SETTING THE TEMPERATURE
**Synthetics-silk
**Wool
***Cotton~linen
-Stand the iron upright
- Set temperature control to ironing temperature.
-Insert the mains plug into the main supply.
-After the indicator light has gone out and comes on again, you may start ironing.
Will go out from time to time during ironing.
STEAM-IRONING
●Set the temperature control to position **for moderate steam and to***for maximum
steam. with conventional steam irons, water may leak from the sole plate if a too low
temperature has been selected.
●Ensure that there is enough water in the water reservoir.
﹣Stand the iron on its heel
﹣Insert the mains plug into the wall socket.
﹣Wait a little while for the indicator light to go out and come on again.
﹣See the variable steam knob to adjust the steam.
BURST OF STEAM
●By pressing button an intense “Burst” of steam is emitted
from the soleplate.
●To prevent water leaking from the sole plate, do not keep the steam control
button depressed for more than 5 seconds.
SPRAY SETTING
●At any temperature by pressing the spray button a couple of time the laundry can be
damped down.
●Ensure that there is enough water in the water reservoir.
DRY IRONING
●Turn the steam knob to the position “ ”(=no steam).
STORAGE
●Remove the mains plug from the wall socket.
●Pour any remaining water out of the water reservoir.
●Set the steam knob to no steam position.
●Stand the iron upright and let it cool down sufficiently.
SELF CLEAN
The function of self clean is to clean the soleplate after using the iron for approximately 6
months.
●Fill the iron and plug in
●when the temperature attaches MAX, press and turn the adjustable steam button
direction from mark “ ” to “ ” ,then pull out the self clean-button for about 1 minute,

then back to its position
●Plug into power in order to dry the soleplate.
●Use the self clean function with caution and over a basin. Hot water is
ejected from the iron and may spill on the user if caution is not exercised.
CLEANING
●Before cleaning the iron ensure it is disconnected from the power supply and has
completely cooled down.
●Deposits on the sole plate may be removed with a rough cloth soaked in a
vinegar/water solution.
●The casting may be wiped with a damp cloth and then polished with a dry one.
●Do not use abrasives on the sole plate.
●Keep the soleplate smooth. Avoid hard contact with metal objects.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban
waste.
It must be taken to a special local authority differentiated waste collection
centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible negative
consequences for the environment and health, deriving form inappropriate
disposal and enables the constituent materials to be recovered to obtain
significant savings in energy and resources. As a reminder of the need to
dispose of household appliances separately, the product is marked with a
crossed-out wheeled dustbin.