VeloChampion CO2 INFLATOR PUMP User manual

INFLATOR PUMP
1 Turn Valve with
Insulated Sleeve
CO2

45o
90oOPEN
CLOSE
2 IN 1
VALVE HEAD
INFLATOR HEAD
LEVER
1.
3.
FOAM
SLEEVE
5.
CO2
CARTRIDGE
(not included)
4.
2.
SAFETY WARNING!
Please ensure the foam sleeve
is over the CO2 cartridge when
activating the cartridge. Please
use VeloChampion gloves when
the cartridge is in use to
prevent injury from cold
temperatures.
Packaging

1. Ensure the lever is set to the off position(c).
2. Slide the foam sleeve over the CO2
cartridge (16g only*).
3. Thread the cartridge clockwise into the
CO2 inflator head and firmly hand tighten
until fully pierced. As the cap of the
cartridge is sealed you will hear a rush of
gas, this is normal. DO NOT remove the
cartridge until empty.
4. Thread the 2 in 1 valve head on to the
Presta or Schrader valve.
5. Slowly turn the lever counter-clockwise
towards a 90oangle to release the CO2 (o).
6. Fill the tyre to the desired pressure.
7. Turn the lever 90oclockwise to close the
valve.
8. Unscrew the inflator’s valve head from the
tyre and keep the inflator head pointing
away from your body to prevent injury.
9. Unscrew and remove the CO2 cartridge
from the CO2 inflator.
*VeloChampion does not supply CO2 cartridges.

In 2009, the VeloChampion brand
was born from passionate cyclists
whose aim was to create high
quality and affordable cycling
accessories and equipment.
We take pride in our products
and hope you like them too. If
you have any feedback, please
leave your comments on the
marketplace you purchased
from, or alternatively contact our
team by emailing
[email protected]