Venset 905 User manual

Copyright 2005, VenSet A/S, VenSet®is a registered trademark
Instruction for Remote system
Article no.: 905 + 906
Installation
oconnect the power supply and the motor unit to the remote receiver. 2 different plug sizes
make this connection only possible to make in the right way
oafter having connected the plugs, the blue light will be lightning
opush the emitter buttons and the motor unit will open and close
ofor stopping the motion one of the buttons need to be pushed
Learning
oif the remote receiver do not respond when pushing the emitter buttons, reset the receiver and
follow the instruction below
opush the learner button on the receiver for less than 1 sec.
opush one of the emitter buttons
othe red LE light will start flashing
opush one of the emitter buttons again and the red light will turn off
othe units now are coded together with a unique code
Reset
opush and hold down the learner button on the receiver for 10 sec. (will be reset when the red
light turns off).
Trouble shooting
ocheck the plug connections
ocheck whether the blue light is on
oreset the receiver and make a new coding

Copyright 2005, VenSet A/S, VenSet®is a registered trademark
Installation
oconnect the power supply’s and the motor unit’s to the remote receiver’s. 2 different plug sizes
make this connection only possible to make in the right way
oafter having connected the plugs, the blue light will be lightning
Learning
ochoose the receiver, which need to be activated by first row of buttons (Window 1).
opush the learner button on the receiver for less than 1 sec.
opush button “Open Window 1”
othe red LE light will start flashing
opush any button and the red light will turn off
othe units now are coded together with a unique code
odo the same for Receiver 2, 3 etc.
Reset
opush and hold down the learner button on the receiver for 10 sec. (will be reset when the red
light turns off).
Trouble shooting
ocheck the plug connections
ocheck whether the blue light is on
oreset the receiver and make a new coding
318650
.0