Ventis Mk II User manual

DIY Filter Change Guide
Step 3: Unscrew the two screws to the
filter door. (Be careful not to lose screws).
Step 4: Open the filter door and turn the ‘P’
clips (securing the filter) to the side so that you
can slide the filter out.
Step 5: Remove the old filter.
Step 6: Insert the new filter ensuring that the
airflow arrow is in the correct
direction. The airflow comes from the fan,
through the filter.
Step 7: Secure the ‘P’ clips around the new
filter by rotating them back to their original
position. Close the filter door securely using
the original screws.
Step 8: Reconnect power supply (plug-in) to fan
unit(s).
Step 9: Now go to the Ventis control panel,
switch your Ventis on by pressing the power button.
Ensure that you dispose of the old filter directly
into the rubbish. PTO for Part Two.
What you will need
1 x Ventis Filter per fan unit
1 x Phillips Head Screwdriver
1 x Torch
Changing your Ventis Mk II filter is a two part process.
1. Changing the fan unit filter in the roof.
2. Resetting the controller (p2).
Warning: Adequate precautions must be taken to enter the roof-space safely, taking into
consideration falls from heights, insulation, wiring and heat.
Part One: Changing the fan unit filter in the roof.
Step 1: Switch the power off on your controller by repeatedly pressing the power button to scroll
through the modes “Auto”, “Flush” until you see “Off”.
Step 2: Disconnect (unplug) the power supply to all fan units with a filter.

Part Two: Resetting the controller.
Step 1: Pop off the faceplate, by
squeezing the sides and gently
removing.
Step 2: Undo the 2 screws. Step 3: Gently pull the controller from the
wall.
Step 4: On the bottom left hand corner,
there is a small rectangle with 4
switches. Flick the top one (1) to the
right using your fingernail, or small
screwdriver.
Step 5: Turn the controller over
and it should read ‘INSTALL’ in
the top left corner.
Step 6: Enter the menu by
pressing the right arrow.
Step 7: Using the down arrow,
scroll down to ‘Filter Details’,
then press the right arrow.
Step 8: Using the down arrow,
scroll down to ‘Reset’. Now
press the right arrow.
Step 9: Press up arrow to “Reset
Now”, then press right arrow.
Step 10: You have now reset
your filter to 100%. Press the
right arrow to EXIT.
Step 11: On the back, flick the
top switch (1) back over to the
left and reattach the controller to
your wall.
Filters need replacing approximately every 12 months. The system will let you know when it’s time for a filter change.
Congratulations - You have now changed and reset your Ventis filter, if you have any questions please do not hesitate to contact us.
press the right arrow.
Filters need replacing approximately every 12 months. The system will let you know when it’s time for a filter change.
Congratulations - You have now changed and reset your Ventis filter, if you have any questions please do not hesitate to contact us.
Ventilation is good for you...pass it on
1800 80 20 80 www.ventis.com.au