VERNON ATLANTA User manual

ATLANTA Installation Guide
Toll: 1.877.490.3537
www.vernontw.com
North Vancouver,
British Columbia, Canada
Distributed by Kartners:

ATLANTA
Long Wall Screw
Plugs
Mounting Tube

-All the dimensions are shown in millimetres/inch
-Horizontal Tube dia 25mm
- Vertical Tube 40mmx30mmxR51
-Bracket length – 27mm
-Rated 100,150,300 or 400W dependent on model
-Suitable for 120V supply, three wire connection
- The electric towel rails conform to: the requirements
of UL499 CSA C22.2 No.60335-1 and E60335-2-43
Please Note:
-All towel warmers contain a factory – filled glycol mixture
-Not suitable for use on domestic hot water system
-Before staring, ensure situation and orientation
Length
Vernon Weight
(KG)
Tapping Centres
(mm)/inch
Fixing Centres (H)
(mm)/inch
Distance (D) Height (mm)/inch Length (mm)/inch
(mm)/inch
ATL-0800600 12.7 550/21.65” 640/25.2” 27/1.06” 800/31.5”
1200/47.24”
600/23.62”
600/23.62”ATL-1200600 18.9 550/21.65” 1040/40.94” 27/1.06”
Tapping Centres
Flow
Return
Height
83
Distance D
80 80
Fixing Centres H
3.15”
3.15”
HARDWIRE KIT SPECIFICATIONS
4 5/16"
2 3/4"
Ø7/8"
Ø1 1/4"
1 1/16"
2 7/8"
Ø1 3/16"
2 3/8"
3.27“
Add the plastic caps onto the top to cover
the screw head and valve.
Install the tube onto the wall screw (2)
Insert the wall screws (2)
into plug (3)
Ensure the fixing lug (1) on the
vertical bar on the back of the
towel warmer.

ELECTRICAL ASSEMBLY
2” x 4” ELECTRICAL BOX
HOT LOAD
(black or blue)
GROUND
(green/yellow)
Junction
box for
optional
control.
NEUTRAL LOAD
(white or brown)
Grounding wire
junction box
cover plate by
ground screw.
With Hardware Kit
-Create a hole in the wall to let the Hard Wire Leg go through (approx. 2 in. x 3
3/4 in.).
-The leg will be covered by Plate so the hole should be large enough to allow
space for electrical connection and leg to go through but not too large so that
the plate can cover it fully.
-Guide the electrical cord through the electrical connection mounting tube and
use the mounting screw to tighten the electrical connection mounting tube to
the vertical bar.
Without Hardware Kit
Guide the electrical cord through the plastic cap and
connect with electrical box.
HARDWIRE INSTALLATION
Step 7
Step 8