VERSARE CTS-1 User manual

Versare Solutions, LLC
3236 California St. NE • Minneapolis, MN 55418
1-855-457-1473 • [e-mail]
Coutertop Shield
Assembly Instructions
Loosely attach 2 Screws and 2 Square Nuts by hand through
the side holes of the first foot. The square nuts should be
positioned on the inside angle of the feet.
Align the foot with the post of the side frame and insert,
matching the square nuts with the exterior channel.
Position the foot assembly so the
buttonhead of the two screws are on
the outside of the Countertop Shield
and slightly tighten each screw with
the included allen wrench, do not fully
tighten.
Repeat the above steps for the second foot assembly.
Tools and hardware included:
1.
2.
3.
4.
Once the second foot has been attached, set the Countertop Shield upright.
Confirm that the Shield is standing straight and perpendicular, adjust as needed
to achieve, then finish tightening all four screws.*
5.

Versare Solutions, LLC
3236 California St. NE • Minneapolis, MN 55418
1-855-457-1473 • [e-mail]
100025 REV A
Helpful Tips:
* To achieve a semi-permanent mount, your
Countertop Shield can be secured to the counter by:
•Appropriate screws and /or anchors matched
to the specific counter material. Attach
hardware (not included) through the holes in
each foot.
•Using double-sided foam tape (not included)
to achieve a secure positioning.
All complete!
We hope you enjoy your new
Countertop Shield!
If you have any questions on your Countertop Shield, please contact us at
1-855-457-1473 or
[e-mail]