VERSARE Straight Wall Sliding Portable Partition User manual

Straight Wall Sliding Portable Partition
Assembly Instructions
Using a small bolt, connect the plate and
washer to the shaft of the wheel.
Screw the wheeled bracket
into the top right corner of
the panel bundle using the
largest screw in the right
whole and the medium
screw in the left hole.
Repeat this process and
screw a second wheeled
bracket into the bottom left
corner opposite of the other
wheel.
Hardware included:
1.
2.
Small
Bolts
Medium
Bolts
Large
Bolts
Washers
Next twist in the remaining wheels into the
panels on both sides, filling every other hole.
3.

100034 REV B
Assembly complete!
We hope you enjoy your new StraightWall Sliding Portable Partition!
For questions regarding your StraightWall Sliding Portable Partition please contact us at
1-855-457-1473 or
[e-mail]
Gently place both end panels on the
ground and lift partition bundle (placing
it on it’s side) on top of one of the end
panels. Screw two bolts into corners of
bracket on the end of the panel. Repeat
last step for the bracket on the other end
of the panel.
3.
Place second end panel on top of
partition. Screw two bolts into corners of
each of the reamaing two brackets.
4.
Gently lift partition onto it’s base & enjoy!
5.
Versare Solutions, LLC
3236 California St. NE • Minneapolis, MN 55418
1-855-457-1473 • [e-mail]