1. Please fold or roll up the damp or pre-moistened towels but not soaked
ones into the wire basket of hot towel warmer. Try to wring out the water
several times to shorten the heating time.
2. The inside wall temperature is 158-176°F. 100% cotton dry towels could
be put as well but not any other cloths which couldn't bear this high
temperature, and keep it within less than 2 hours heating. Please keep the
towel away from the inner wall of warmer.
3. Do not overload the wire basket or directly place towels into the towel
warmer.
4. Close the door firmly and press the Power button to turn on. The
indicator near the switch will be on to show that the towel cabinet has
started heating.
5. In about 1.5-2.5 hours, depending on how many towels you put inside,
while keeping the door closed, the temperature inside the cabinet will heat
up to approximately 158-176°F and will be kept automatically. Avoid
opening cabinet when towels are heated.
6. Tum off the power button whenever you want to add more towels. The
heating process will be restarted. The thermostat will automatically stop
working when temperature reaches 158-176°F. It's safe to keep it on.
7. If desired, press the UV button to turn on EPA-registered UV sterilization
system. The indicator near the switch will be on to show that the UV light is
working. Wait 30 minutes for the sterilization process to complete.
8. Whenever you want to open the door, please first turn off the power with
the indicator light off. Stay a safe distance from the cabinet door opening to
avoid being burned by high-temperature steam from the cabinet. Remove
towels with tongs or heat-resistant gloves.
9. Towels may be too hot to apply immediately, and caution should be
used before applying to the face or body.
