Viatek PEDISPA VCAL-1 User manual

PEDI SPJ\:
VACUUM CALLUS REMOVER
INSTRUCTION MANUAL

PARTS DIAGRAM
Power Button
Operation
Indicator
Light
Charging Port
Exhaust Port
Cleaning Brush
Exfoliating Head
Coarse Grit
Cx.z)
Exfoliating Head
Cover
Exfoliating Head
Fine Grit Exfoliating
Head
Cover Cap
USB Charging Cable

IMPORTANT SAFEGUARDS
When using electricalproducts, especiallywhen children are
present, basic safety precautions should always be followed,
including
the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER
To reduce the risk of electrocution:
Do not usewhile bathing.
Do
not place orstore product where it can fall or be pulled into a
tub or sink.
Do
not place in or drop intowater or other Liquid.
Do not reach for a product that has fallen into water.
Unplug immediately.
Do
not put unit or powercord in water or other Liquid.
This unit is not waterproof or water resistant. Do not use
nearwater.
Unless charging, always unplug from the
outlet when not in use.
Do
not abuse or damage the power cord.
Unplug unit before cleaning.
Do
not attempt to alter the plug or cord in anyway.
WARNING
To reduce the risk of burns, electrocution, fire, or injury to persons:
Productshould never be Left unattended when plugged in.
Close supervision is necessarywhen this product is used by, on,
or near children or invalids.
Use this product onlyfor its intended use
as described in
this manual. Do not use attachments not recommended by
the manufacturer.
Neveroperate this product
if it has a damaged cord or plug, if it
is not working properly, if it has been dropped or damaged, or
dropped into water. Return the product to a service center for
examination and repair.
Keep
the cord away from heated surfaces.
Never
block the air openings of the product or place it on a soft
surface, such as a bed or couch, where the air openings may be
blocked. Keep
the air openings free of Lint, hair, and the Like.
Never drop or insert any object into anyopening.
Do
not use outdoors or operate where aerosol(spray) products
are being used
or where oxygen is being administered.

• Only use on clean, dry, Lotion-free skin.
Be sure
the plug and outlet are a safe distance from any
water source.
•
To clean the exterior of the unit. unplug and use a damp cloth
with optional mild detergent.
Ifdevice appears
to be damaged, DO NOT USE.
• Any attempt to open the unit will void the warranty.
• Always attach
plug to unit. then to USB port. To disconnect. turn
unit
off and unplug from outlet.
•
When unplugging, pull on the plug and not on the cord.
Do
not wrap cord around the unit.
NEVER handle
the unit or power cord with wet hands.
Be sure that there are no foreign objects inside
the unit.
Make sure unit
is properlyassembled and all moving parts are
Locked into place before use.
Do
not use attachments not recommended by manufacturer.
For hygienic reasons, this unitshould
only be used on one person.
• Only use device for its intended purpose.
Household use only.
Do
not use outdoors.
Keep
out of reach of children.
• Store
in a cool. dry place. Do not Leave in directsunlight.
• CAUTION:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
USE INDOORS ONLY.
• CAUTION: HIGH VOLTAGE. KEEP OUT OF REACH OF CHILDREN.

SAVE THESE INSTRUCTIONS
OTHER PRECAUTIONS
When unit is on, keep awayfrom hair on yourscalp, eyebrows,
eyelashes, clothes, brushes, wires, cords, shoelaces, oranything else
that might become caught
in the unit.
Consult a
doctor before use if you have any of the following conditions:
•Allergic
or sensitive
skin
that reacts to
cosmetics, metals,
clothing, etc.
•Acne
or body acne
•Warts
• Moles or loose skin
in area to be treated
• Diabetes
• Raynaud's disease
• Eczema
• Psoriasis
• Hemophilia
• Immunedeficiency
• Rosacea
•Couperose
•Varicose veins
•Wounds
• Rash, sunburn,
inflammation, or
irritation
•
If pregnant or
recently pregnant
•
If you have a
pacemaker

OPERATION
The exfoliating head is designed for removing coarse, callused skin
from
feet and heels. Do not use anywhere else on the body. Do not
use on broken or bleeding skin.
Wash and completely dryskin that is to be treated. Remove the
cap and press the power button to turn on to
low speed (1). The
exfoliating head
will start spinning and the operation light will light
up blue. Touch the exfoliating head to the area on your foot thatyou
would like to treat.
Press gently at first, then apply more pressure
and/or increase to high speed (2) by pressing the power button again
(the operation light
will be solid red on high speed mode). Ifyou press
too hard, the exfoliating head
will stop spinning. Gently move the unit
back and forth orside to side for no more than
2-3 seconds at a time
untilcallused skin
is removed. For a smootherappearance, switch
to the fine gritexfoliating head and repeat these steps.
Press the
power button a third timewhile operation light
is solid red to turn the
device
off.
NOTE: As soon as you feel the exfoliating head touch new, healthy
skin, orwhen
the callus has been removed, stop use.

CHANGING EXFOLIATING HEADS
1. Turn product offand remove exfoliating head cover by pulling
offexfoliating head.
2. Press release button as shown in diagram and pull exfoliating
head upward
to remove.
3. Insert one side of replacement exfoliating head into square
groove on side
of the devicewith the release button.
4. Press opposite side of exfoliating head into place in the op-
posite square groove. You will hear new head click into place
when installed.
5. Replace exfoliating head cover.
-+

CHARGING
When battery is low the operation light will blick red. When battery is below
operating values, operation light will blink three times and device will shut
down. To charge device, plug charger into charging port. While charging,
the operation light will glow red when the battery is low and green when
fully charged. Low power indicated by blinking red lighton all modes.
CLEANING
Remove exfoliating head cover and rinse device under running water to clean.

SPECIFICATIONS
Charging Voltage: 5v
Charging Current: 1A
Origin: China

NOTES

NOTES

PEDI SP~
A Read Instructions
ft Before Operating
MADE IN
CHINA PATENT
PENDING Rev: 121619
VIATEKPRODUCTS.COM
For questions, assistance, or replacement parts, do not retum to your retailer. Contact Viatek9 customer service below.
For refunds on items not purchased from Viatek® directly, please contact your retailer.
VIATEK® 1-YEAR LIMITED WARRANTY
Viatek® warrantsthis product to be free of manufacturing defects. Should anysuch defect develop or becomeevidentwithin oneyearfrom
the date of purchase,
Viatek® will replace the entire product or, at its option, repair or replace the defective part(s) without charge.
Contact
Viatek® customer service at 888.784.2835 or at [email protected] to determine whether it is necessary to return the unit. To return,
securely pack the entire unit. Be sure carton clearly identifies sender
by name and address. Attach a letter or card describing defect and
original sales receipt. Mail prepaid
to Viatek Consumer Products Group, Inc. 6011 Century Oaks Dr. Chattanooga, TN 37416.
This warranty is void if damage or malfunction is due
to abuse or failure to operate product in accordance with instructions and on
recommended electrical current. This warrantygives you specific legal rights and you may also have other rights which vary from state
to
state. If you have any questions, or would like to learn more about Viatek®, please contact us at 888.784.2835 or at [email protected].
Register your product online atviatekproducts.com/register-your-product-warranty/
Customer Service / Le service a la clientele / Servicio al Consumidor
\. 888. 784.2835 (+ 1.423.402.9010) m [email protected]
Model:
VCAL-1
DO NOT DISPOSE OF BATTERIES IN FIRE. ALWAYS DISPOSE OF BATTERIES PER LOCAL & FEDERAL GUIDELINES.
© 2019 VIATEK CONSUMER PRODUCTS GROUP, INC. All specifications are subject to change without notice. All rights reserved.
Viatek
Consumer Products Group, Inc. 6011 CenturyOaks Dr. Chattanooga, TN 37416
Click Here To Read More...
PediSpa Vacuum Callus Remover Instruction Manual [VCAL-1]