Viking Electronics 40TB-IP User manual

40TB-IP
SIP Multicast Talk-Back
Speaker
September 17, 2019
1.0 Out-of-Box
1.1 Verify that you have received all of the parts listed
40TB-IP Speaker
Qty: 1
2.0 Power Source
• Make sure the port is not in trunk mode
• Make sure port is capable of 100mbps full duplex
• Disable Spanning Tree Protocol (STP) or enable Portfast
QUICK START GUIDE
VIKING Electronics, Inc.
Select PoE Switch or PoE Injector that meets the following requirements:
1. IEEE 802.3af / 802.3at / 802.3bt compliant
2. Capable of providing at least 13 Watts (class 0 or class 3)
Note: CAT5e (or higher) cable recommended
3.0 Network Port Settings
1.3 Download and install the programming software
1. Go to www.vikingelectronics.com and enter 40TB-IP in the search box
2. Click 40TB-IP in the search results
3. Scroll down the page to Downloads, click IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on
setup Viking IP Programming.exe
5. Follow the prompts on your screen to complete software installation
KSee Product Manual for complete installation and programming instructions.
8-position terminal block
Qty: 1
1.2 Download the product manual
1. Go to www.vikingelectronics.com and
enter 40TB-IP in the search box
2. Click 40TB-IP in the search results
3. Click Product Manual to open and
download the PDF
Scan the QR code to
open and download
the product manual - OR -

4.0 Features Overview
Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries
assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.
See the Product Manual for complete installation and programming instructions.
Questions? Call Viking Product Support: 715-386-8666
40TB-IP Quick Start Guide ZF303945 REV A
40AE
Speaker
Out
Relay Output Contact
(2A@30VDC/ 250VAC maximum)
MAC Address Label: The MAC
address is a unique 12 digit number
used by routers to send network
traffic to the correct IP address.
PoE LAN Port 10/100, PoE Class 3 (<13 Watts):
Connect to your LAN via RJ45 plug and CAT5 or
greater twisted pair wire.
Yellow Network Status LED: Lights
steady to indicate power and data link.
Blinks to indicate network activity.
(Power typically not required
for gate controllers)
Doorstrike / Magnetic Lock
120V AC
Connect to Optional Doorstrike,
Mag Lock, Gate Controller, etc.
Green Unit Status LED
Line
Out
Side View
Adjustable Mounting Clamps
VIKING©
VIKING
ELECTRONICS
HUDSON, WI 54016
60 WATT 2 ZONE
POWER AMPLIFIER
PWR 60 W
+/ 24 VDC
MODEL PA-60
SPKRS
PWR
LED
SPKRS LINE LEVEL AUDIO INPUT
GAIN GAIN
70V OUT
SPKRS SPKRS LINE LEVEL AUDIO INPUT
70V OUT
CHANNEL 2CHANNEL 1
2315 7101112
46 89
Up to (15)
8 Ohm
Speakers
600 Ohm
Paging Audio
Optional Viking Model PA-60
Paging Amplifier (DOD 493)
Optional Momentary Switch Input
to initiate outbound calls (not included)
Momentary
Reset Switch (see sections D and E
on page 9)
30AE 25AE 35AE
Up to (5) Optional Viking Analog Speakers
(not included, see DOD 497 and 498)
300AE
Volume Control
Microphone: Omni-directional
microphone with protective
water-resistant cloth.
Speaker: 8” paper
with wizzer cone
Blue Call/Status LED: Flashes
during dialing, then lights steady
when answered.
Front View
Up to (15)
8 Ohm
Speakers
Up to (15)
8 Ohm
Speakers
Up to (15)
8 Ohm
Speakers