VINGLI FT-VA01 User manual

A D
B E
C F
H
I
G
J
FT-VA01---Parts List
90° Arch-Male 1 1/2”x 1 1/2”
Arbor Post
Side Connection
1 1/2”x 2/5”
Picket
90° Arch-Female
Top Connection
1 1/2”x 7/8” Cross Member
1 1/2” Stake
1 1/2”x 7/8” Cross Member (With single side holes)
1 1/2”x 7/8” Cross Member (With double side holes)
2
2
2
6
4
4
6
4
6
4
Garden Arbor
Thank you for purchasing from VINGLI！
PLease contact us via email if parts are mising or damaged, we will gladly ship
your replacement parts free of charge.

Assembly Instruction
Step 1
Slide one of the Arch sections into the
Top Connection
Step 2
Step 3
Step 5 Step 6
Step 4
Slide second Arch section into the Top
Connection then put the Connection
cover. Use screw,to fix the Connection.
Repeat this process for the second arch. They
should look as shown above.
Insert (3) 1 1/2”x2/5“ Picket into (3) 1
1/2” x7/8”Corss Member (With double
side holes)
Insert (3) 1 1/2”x2/5“ Picket into (2) 1
1/2” x7/8”Corss Member (With single
side holes)
Insert (6) 1 1/2” x7/8”Corss Member
into one of the assembled Arches.
Place the second Arch assembley against
the opposite end of the Cross Bars and
install them one at a time until both Arch
halves are fully together.
Notch
AC
B
A
H
EJI
I

Step 7
Insert (5) 1 1/2” x7/8”Corss Member into
the pre-routed Arbor Post to attach (2)
Arbor Post with the assembled side panel.
Repeat this step to create another Arbor
side
Step 8
Step 9
Step 11
Step 10
Slide two (2) Side Connection on the short
ends of each of the Arbor Posts. Same as
step 1 and step 2.
Repeat this step to create another Arbor
side.
Draw four markers on the ground. The
markers should be spaced apart as shown in
the diagram above.
Put the assembled side panel on the
stake with two (2) Arbor Post. It should
be10” stake into the Arbor Post
Insert the stake in the marked position. 10” above the
ground and 10” under the ground.Repeat this step to
insert the another three (3) stakes.
Step 12
Put another assembled side panel on the
stake with two (2) Arbor Post. It also
should be10” stake into the Arbor Post
10”
10”
Notch
21.9”
39.6”
DF
G

Step 13 Step 14
Install the Arch onto the top of the Arbor
Posts as shown above.
Perfectly completed the Arbor installation
job.
Drawing
51.1in
129cm
21.9in
55.6cm 39.6in
100cm
86.2in
219cm
10in 26cm