VIO HALCYON STRIP Original instructions
HALCYON STRIP
Please read the installation manual carefully before commencement
of installation.
Before carrying out any installation, please ensure that all power is switched
off and disconnected from the main power supply.
This product must be installed by a qualified installer under local regulations.
The light source of the luminaire is not replaceable.
When the light source reaches its end of life, the whole luminaire
shall be replaced.
VIO
GENERAL INFORMATION
Product Support
Product support shall be provided by VIO
as long as this product is still under warranty.
VIO is not obliged to provide any repairs/
replacement on defects and damages caused
by improper installation, improper operation,
wrongful cleaning agents that deteriorate the
surface appearance, force majeure and/or
modifications made by user or third party.
Cleaning and Care
Before cleaning, disconnect the luminaire
from main supply and allow it to cool.
Clean the external surface using lint free
cloth with alcohol-free and non-abrasive
cleaning agent.
Corrosion Protection
Do not expose luminaire to corrosive agents
(e.g. salt, acid, chemical & cleaning agents)
during installation or cleaning. These agents
may cause corrosion on the luminaire.
Ambient Condition
LED luminaire performs best in an ambient
temperature of <35°C.
High ambient temperature may reduce the
lifespan and eciency of the LED driver
and luminaire.
Sizing Variation
A
Product A B
B
C
LED STRIP -1ft
LED STRIP -2ft
LED STRIP -3ft
LED STRIP -4ft
310
610
910
1210
17.5
C
7
17.5 7
17.5 7
17.5 7
Installation Manual and Safety Instruction
www.vio.com.sg
INSTALLATION INSTRUCTIONS
LED STRIP
1 2
3 4
1. Ensure that you have received (A) LED strip, (B) a control box and
(C) a LED driver. Before installation or servicing, turn off and disconnect from
main power supply.
2. Connect the (C) LED Driver to the main power supply. Connect the (B) control
box to the (C) LED Driver. Connect the (A) LED strip to the (B) control box.
3. To extend the (A) LED strip, connect the jack of the (A) LED strip to the plug of
another (A) LED strip. Do note that a single (B) LED driver could only support up
to 5 metres of (A) LED strip.
4. Do not cut the loose connection at the end of the (A) LED strips.
Control box LED driver
LED strip
v- v+
NL
v- v+
NL
maximum combined length: 5 meters
A
A
B
B
C
C
D
